Work Zone Temporary Traffic Control Tech Pre-Quiz
Comprehensive Resource To Help You Ace 2026-
2027 Exams Includes Frequently Tested Questions
With ELABORATED 100%
Correct COMPLETE SOLUTIONS
Guaranteed Pass First Attempt!! Current Update
1. The work zone starts at the first advance warning sign; therefore, where
should the flagger stand when directing traffic in a TTC (work) zone? -
Correct Answer: on the shoulder adjacent ti traffic being controlled
2. How many orange and black TTC signs should there be in each direction on
a 2-way, 2-lane rural roadway? - Correct Answer: Three
3. Orange and black TTC signs in each direction on a 2-way, 2-lane rural
roadway what should the signs spacing be - Correct Answer: 500ft
4. How many feet apart should the advanced warning signs be on a high speed
urban roadway? - Correct Answer: 350
5. Advanced warning signs for additional emphasis, signs may be posted -
Correct Answer: on the left hand side of the highway
6. Taper length refers to: - Correct Answer: the distance required to safely
route traffic from one lane to another
,7. The taper length is based upon: - Correct Answer: width of the lane
closed and speed of the roadway
8. In a taper, the maximum distance between channelizing devices should be: -
Correct Answer: equal in feet to the speed limit
9. On a barricade, if the stripes start at the upper right side and angle down to
the lower left side; - Correct Answer: traffic should pass to the left
10.At night time and/or on high speed roads greater than 45 mph, cones shall
be: - Correct Answer: retoreflectorized and have at least two white
bands/stripes and at least 28" tall
11.On a rural, 2-lane road, where would you place the flagger in respect to the
beginning of a taper for a closed lane? - Correct Answer: at the
beginning of the taper
12.The STOP/SLOW paddle is preferred over the flag - Correct Answer: True
13.Flags may be used in which of the following situations? - Correct
Answer: emergencies
14.If used at night, the flag needs not to be retoreflectorized as long as the
flagger station is floodlit. - Correct Answer: True
, 15.When flagging at a spot obstruction, a position may have to be taken on the
shoulder opposite the barricaded section to operate effectively -
Correct Answer: True
16.During nighttime conditions, arrow boards needs to be reduced in
brightness - Correct Answer: true
17.Which factors should you consider in formulating a TTC plan? - Correct
Answer: type of work to be done
traffic volume
traffic speed
school bus routes
18.The rerouting of traffic onto a temporary bypass road is known as a: -
Correct Answer: diversion
19.Parking signs are classified as: - Correct Answer: regulatory
20.Pavement markings no longer needed should be removed by: - Correct
Answer: grinding
21.A TTC zone should be checked: - Correct Answer: routinely
22.Traffic control devices include: - Correct Answer: Signs
Comprehensive Resource To Help You Ace 2026-
2027 Exams Includes Frequently Tested Questions
With ELABORATED 100%
Correct COMPLETE SOLUTIONS
Guaranteed Pass First Attempt!! Current Update
1. The work zone starts at the first advance warning sign; therefore, where
should the flagger stand when directing traffic in a TTC (work) zone? -
Correct Answer: on the shoulder adjacent ti traffic being controlled
2. How many orange and black TTC signs should there be in each direction on
a 2-way, 2-lane rural roadway? - Correct Answer: Three
3. Orange and black TTC signs in each direction on a 2-way, 2-lane rural
roadway what should the signs spacing be - Correct Answer: 500ft
4. How many feet apart should the advanced warning signs be on a high speed
urban roadway? - Correct Answer: 350
5. Advanced warning signs for additional emphasis, signs may be posted -
Correct Answer: on the left hand side of the highway
6. Taper length refers to: - Correct Answer: the distance required to safely
route traffic from one lane to another
,7. The taper length is based upon: - Correct Answer: width of the lane
closed and speed of the roadway
8. In a taper, the maximum distance between channelizing devices should be: -
Correct Answer: equal in feet to the speed limit
9. On a barricade, if the stripes start at the upper right side and angle down to
the lower left side; - Correct Answer: traffic should pass to the left
10.At night time and/or on high speed roads greater than 45 mph, cones shall
be: - Correct Answer: retoreflectorized and have at least two white
bands/stripes and at least 28" tall
11.On a rural, 2-lane road, where would you place the flagger in respect to the
beginning of a taper for a closed lane? - Correct Answer: at the
beginning of the taper
12.The STOP/SLOW paddle is preferred over the flag - Correct Answer: True
13.Flags may be used in which of the following situations? - Correct
Answer: emergencies
14.If used at night, the flag needs not to be retoreflectorized as long as the
flagger station is floodlit. - Correct Answer: True
, 15.When flagging at a spot obstruction, a position may have to be taken on the
shoulder opposite the barricaded section to operate effectively -
Correct Answer: True
16.During nighttime conditions, arrow boards needs to be reduced in
brightness - Correct Answer: true
17.Which factors should you consider in formulating a TTC plan? - Correct
Answer: type of work to be done
traffic volume
traffic speed
school bus routes
18.The rerouting of traffic onto a temporary bypass road is known as a: -
Correct Answer: diversion
19.Parking signs are classified as: - Correct Answer: regulatory
20.Pavement markings no longer needed should be removed by: - Correct
Answer: grinding
21.A TTC zone should be checked: - Correct Answer: routinely
22.Traffic control devices include: - Correct Answer: Signs
