IAAI CFI EXAM STUDY QUESTIONS ACTUAL EXAM LATEST
2025/2026 COMPLETE QUESTIONS UPDATED VERSION
Leave the first rating
Save
Students also studied
Flashcard sets Study guides
Chapter 28 Practice Test Marine Fire... Comprehensive PA-28-181 Flight and... Wood Structures NA
30 terms 21 terms 41 terms 72
Shelby-Chap Preview Kenedy_Darosa2 Preview Bruno_Leite1 Preview
Terms in this set (257)
A liquid with a flash point ABOVE 100F Combustible Liquid
If the current flowing out from an electrical panel is 12.5 12.5
amps, and it then flows through an electrical load of
1500 watts, what is the amperage of the remaining
current flow of the return circuit?
If a hair dryer draws 8.3amps (in a home with 120-volt 1000
service), what is the wattage?
*Power (P) = current (I) x voltage (V)
Watts = amps x volts
The year of the first edition of NFPA 1033 1987
The recommended distance for securing the perimeter 1.5 times
of a blast scene
*That is, the distance from the furthest debris
What temperature in the upper gas layer causes the 1100°F
onset of Flashover?
The temperature at which copper melts 1960°F
The measurement of the radiant heat flux (from gas 2 W/cm2
layer to the floor) that indicates the onset of flashover
, The voltage between the two hot wires at the service 240 volts
entrance cables in most single-family residences in the
United States (single-phase service with three wires)
The revision cycle for NFPA 921 (timespan) 3 years
The flash point of power steering fluid 350°F
In high-pressure fuel-injected vehicles, this is the typical 35-70 p.s.i.
range of pressure that is used to pump fuel from a fuel
tank
The lower explosive and upper explosive limit of 5 and 17
natural gas (methane)?
The ignition temperature of power steering fluid 680°F
Any substance that can undergo combustion Fuel
Two factors or situations leading to a fire that may show Act or Omission
the nature of the incident responsibility.
This concept should not be included in a summary Additional Investigative Recommendations
report of findings.
A law that may govern the fire investigation of a boat Admiralty Law
A type of device in a vehicle, which can cause an After-market Equipment
electrical overload to factory installed wiring
Evidence of smoke or soot in the lungs, bronchi, and Alive and Breathing
trachea is one of the most significant factors in
confirming that, at the time of the fire, the victim was
WHAT?
Those who have the responsibility for monitoring safety All Team Members
conditions at the fire or explosion scene
The melting temperature of aluminum 1220°F
Which one of these is NOT considered a competent Aluminum-to-pavement sparks
ignition source?
Metal-to-metal sparks,
Aluminum-to-pavement sparks,
Metal-to-pavement sparks,
Motor bearing sparks
2025/2026 COMPLETE QUESTIONS UPDATED VERSION
Leave the first rating
Save
Students also studied
Flashcard sets Study guides
Chapter 28 Practice Test Marine Fire... Comprehensive PA-28-181 Flight and... Wood Structures NA
30 terms 21 terms 41 terms 72
Shelby-Chap Preview Kenedy_Darosa2 Preview Bruno_Leite1 Preview
Terms in this set (257)
A liquid with a flash point ABOVE 100F Combustible Liquid
If the current flowing out from an electrical panel is 12.5 12.5
amps, and it then flows through an electrical load of
1500 watts, what is the amperage of the remaining
current flow of the return circuit?
If a hair dryer draws 8.3amps (in a home with 120-volt 1000
service), what is the wattage?
*Power (P) = current (I) x voltage (V)
Watts = amps x volts
The year of the first edition of NFPA 1033 1987
The recommended distance for securing the perimeter 1.5 times
of a blast scene
*That is, the distance from the furthest debris
What temperature in the upper gas layer causes the 1100°F
onset of Flashover?
The temperature at which copper melts 1960°F
The measurement of the radiant heat flux (from gas 2 W/cm2
layer to the floor) that indicates the onset of flashover
, The voltage between the two hot wires at the service 240 volts
entrance cables in most single-family residences in the
United States (single-phase service with three wires)
The revision cycle for NFPA 921 (timespan) 3 years
The flash point of power steering fluid 350°F
In high-pressure fuel-injected vehicles, this is the typical 35-70 p.s.i.
range of pressure that is used to pump fuel from a fuel
tank
The lower explosive and upper explosive limit of 5 and 17
natural gas (methane)?
The ignition temperature of power steering fluid 680°F
Any substance that can undergo combustion Fuel
Two factors or situations leading to a fire that may show Act or Omission
the nature of the incident responsibility.
This concept should not be included in a summary Additional Investigative Recommendations
report of findings.
A law that may govern the fire investigation of a boat Admiralty Law
A type of device in a vehicle, which can cause an After-market Equipment
electrical overload to factory installed wiring
Evidence of smoke or soot in the lungs, bronchi, and Alive and Breathing
trachea is one of the most significant factors in
confirming that, at the time of the fire, the victim was
WHAT?
Those who have the responsibility for monitoring safety All Team Members
conditions at the fire or explosion scene
The melting temperature of aluminum 1220°F
Which one of these is NOT considered a competent Aluminum-to-pavement sparks
ignition source?
Metal-to-metal sparks,
Aluminum-to-pavement sparks,
Metal-to-pavement sparks,
Motor bearing sparks
