FLORIDA FINAL PAPER 2026 COMPLETE
SOLUTIONS AND VERIFIED ANSWERS
GRADED A+
⩥ An Inspector Cannot be held liable for acts they consider necessary to
fulfill their responsibilities. Answer: An Inspector Can be held liable for
the manner in which they perform acts.
⩥ What three things should an Inspectors report do? Answer: Inform,
Analyze, Recommend
⩥ Is a partition wall load bearing? Answer: No
⩥ In a lodging or rooming house where a sleeping room is above the
level of exit discharge, the primary means of escape shall be what?
Answer: Enclosed Stairway
Horizontal Exit
Exterior Stair
Fire Escape
⩥ Orthographic projections are what?? Answer: 3 dimensional
,⩥ A booster pump is? Answer: boost pressure for fire surpression
⩥ What is the difference between interior and exterior plywood?
Answer: Glue
⩥ What is the NFPA Standard number that covers Fire Inspections?
Answer: NFPA 1031
⩥ In what ways is steels strength used? Answer: Tension and
compression
⩥ What is the rate of rise for a Class B ramp? Answer: 1 foot for 8 feet
of length
⩥ regarding solid piling storage it presents fewer paths for fire
development because of ?? Answer: no horizontal voids and stacks
directly on top of each other.
⩥ What does PIV and WPIV stand for? Answer: Post indicator Valve
Wall post indicator Valve
⩥ For a 4" sprinkler riser, how wide must the main drain be? Answer: 2
inches
, ⩥ What is Cold Flow? Answer: caused by heating sprinkler head to
close to temperature.
⩥ What is "Stack Effect?" Answer: Strong air flow patterns in high rise
structures.
⩥ How often should a Halon Extinguishing System be tested? Answer:
Semi annually
⩥ What type of Class A fire is Halon not very effective on? Answer:
Deep seated fires
⩥ How often are Fire Service Elevators tested? Answer: Monthly
⩥ Explain pressure relieving valves Answer: Any outlet that may have
an outlet pressure greater than 100psi
NFPA 14 requires the PRV limit outlet pressure to 100psi.
Top of Page 13
⩥ Internal Pressures of Extinguishers Answer: vary from 100 to 850
⩥ The Class B Rating Test... Answer: 1 Square foot of fuel for 1-B
rating