IMSA TRAFFIC SIGNAL TECHNICIAN LEVEL 2 COMPREHENSIVE STUDY GUIDE 2026 PRACTICE QUESTIONS AND ACCURATE ANSWERS GRADED A+

IMSA TRAFFIC SIGNAL TECHNICIAN LEVEL 2
COMPREHENSIVE STUDY GUIDE 2026
PRACTICE QUESTIONS AND ACCURATE
ANSWERS GRADED A+

◉ IMSA stands for: Answer: International Municipal Signal
Association


◉ Which of the following is NOT an IMSA certification? Answer: Y:
Traffic Signal Level II Design/Engineer Technician
Y: Traffic Signal Level II Field Technician
Y: Traffic Signal Level II Bench Technician
N: Traffic Signal Level III Bridge Design Technician


◉ Which of the following are potential safety hazards? Answer:
Overhead and underground power
Gas
Aerial lift equipment


◉ What are the sections of a ramp meter signal? Answer: Circular
red, circular green

, ◉ PPE stands for: Answer: Personal Protective Equipment


◉ Which of the follow is an example of adequate fall protection
during the operation of aerial lift equipment? Answer: Full body
harness
Safety belt
Rails of a platform lift


◉ Work Zone Supervisor is responsible for which of the following
tasks? Answer: Ensure advance warning devices have not been
removed or relocated


◉ Which of the following is NOT a sentence type in the MUTCD?
Answer: Y: Standards; requirements that have to be followed
Y: Guidance; recommendations that are to be followed unless there
is a good reason not to
N: Objectives; reasons behind the standards and guidance
y: Support; additional information to clarify the standards and
guidance


◉ Which of the following is an example configuration of an
Emergency-Vehicle Traffic Control Signals: Answer: Three-section
traffic signal with circular red, circular yellow, and smaller circular
yellow indications