NCCCO Overhead Crane (2026) EXAM || MOST RECENT
EXAM 2026-2027 ACTUAL COMPLETE REAL EXAM QUESTIONS
AND CORRECT ANSWERS (VERIFIED ANSWERS) ALREADY
GRADED A+ | GUARANTEED SUCCESS!! NEWEST EXAM |
JUST RELEASED!!
According to O.S.H.A. the operator shall not hoist loads
above? - ANSWER -
Personnel
Where should the hook block be positioned for shutdown? -
ANSWER -Near the
upper
limit
Whose responsibility is it to select the proper rigging
equipment? - ANSWER -
Operator
Before making a lift the operator must first determine? -
ANSWER -Weight of
the
load
,A wire rope designated as 6 X 19 has? - ANSWER -6 strand with
19 wires
What is the safe working load (SWL) of a wire rope defined
as? - ANSWER -
Breaking strength divided by
safety factor
The vertical movement of an overhead crane is controlled by
the? - ANSWER -
Hoist
controller
Swinging loads can be controlled by use of the? - ANSWER -
Bridge and trolley
controls
First step in daily inspection would be to check? - ANSWER -
Main switch locked
in off
position
If the load does not balance properly after being raised, what
step should be
taken? - ANSWER -Lower the load to
the ground
, When making a lift, what position should the trolley be in? -
ANSWER -Vertical
to the
load
What position should all controllers be in when energizing? -
ANSWER -Either
neutral or
off
ASME B.30,2 states that the minimum number of wraps on the
hoisting drum should never be less than__________ unless a
lower limit device is provided. - ANSWER -Two wraps
Before leaving a crane cab unattended, any attached load shall
be? - ANSWER
-
Landed
What is the purpose of the upper limit switch (the only one
required by OSHA)?
- ANSWER -Limit the hoist
travel
When any machinery or apparatus is found to be defective or
inoperative on the
crane, the
person
EXAM 2026-2027 ACTUAL COMPLETE REAL EXAM QUESTIONS
AND CORRECT ANSWERS (VERIFIED ANSWERS) ALREADY
GRADED A+ | GUARANTEED SUCCESS!! NEWEST EXAM |
JUST RELEASED!!
According to O.S.H.A. the operator shall not hoist loads
above? - ANSWER -
Personnel
Where should the hook block be positioned for shutdown? -
ANSWER -Near the
upper
limit
Whose responsibility is it to select the proper rigging
equipment? - ANSWER -
Operator
Before making a lift the operator must first determine? -
ANSWER -Weight of
the
load
,A wire rope designated as 6 X 19 has? - ANSWER -6 strand with
19 wires
What is the safe working load (SWL) of a wire rope defined
as? - ANSWER -
Breaking strength divided by
safety factor
The vertical movement of an overhead crane is controlled by
the? - ANSWER -
Hoist
controller
Swinging loads can be controlled by use of the? - ANSWER -
Bridge and trolley
controls
First step in daily inspection would be to check? - ANSWER -
Main switch locked
in off
position
If the load does not balance properly after being raised, what
step should be
taken? - ANSWER -Lower the load to
the ground
, When making a lift, what position should the trolley be in? -
ANSWER -Vertical
to the
load
What position should all controllers be in when energizing? -
ANSWER -Either
neutral or
off
ASME B.30,2 states that the minimum number of wraps on the
hoisting drum should never be less than__________ unless a
lower limit device is provided. - ANSWER -Two wraps
Before leaving a crane cab unattended, any attached load shall
be? - ANSWER
-
Landed
What is the purpose of the upper limit switch (the only one
required by OSHA)?
- ANSWER -Limit the hoist
travel
When any machinery or apparatus is found to be defective or
inoperative on the
crane, the
person
