STUDY GUIDE COMPLETE QUESTIONS
WITH CORRECT SOLUTIONS||100%
GUARANTEED PASS||UPDATED
2026/2027 SYLLABUS||A+
GRADED||<<RECENT VERSION>>
KANNAD 406 SURVIVAL - PURPOSE - ANSWER ✓ The emergency locator
transmitter (ELT) provides a homing signal for search airplane by automatically
transmitting a signal simultaneously on civil and military international UHF
aeronautical distress frequencies.
KANNAD 406 SURVIVAL - MODES - ANSWER ✓ a) ON - Used for manual
activation of ELT transmission.
b) ARM - ELT transmission will commence on immersion in water.
c) OFF - Deactivates ELT transmission.
KANNAD 406 SURVIVAL - PFC - ANSWER ✓ a) Correct quantity;
b) Correct location and secured in brackets; and
Toggle switch of ELT is in ARM position with water switch sensor connected.
KANNAD 406 SURVIVAL - DURATION - ANSWER ✓ 48 Hours
KANNAD 406 SURVIVAL - Operation on Water - ANSWER ✓ a) Secure End
of Lanyard CordSecure end of lanyard cord to a suitable tethering point as close as
possible to the edge of the raft on the same side as the sea-anchor tie point.
b) Put the Transmitter Overboard into the WaterPut the ELT in the water to float
safely. The ELT should float with the antenna in the vertical position. Check that
buzzer operates and visual indicator flashes periodically.
, KANNAD 406 SURVIVAL - Caution - ANSWER ✓ When more than one
transmitter is available, it is only necessary to operate one at a time. For this
reason, it is important that the rafts should be tied together if possible.
KANNAD 406 SURVIVAL - Operation on Land - ANSWER ✓ a) Select Area to
Transmit
Carry transmitter to an area with minimum obstruction (such as trees, hills, etc.),
which could interfere with the radiated signals.
b) Select the ELT switch to ONPlace the ELT toggle switch in the ON position.
c) Keep the Antenna Upright
d) Transmission on the KANNAD 406 SURVIVALThe ELT starts with the self-
test sequence. After its self-test sequence, the ELT will start transmitting distress
signal.
A buzzer operates, and visual indicator flashes periodically confirms unit is
functioning. To switch the transmitter off, place the ELT toggle switch in the OFF
position.
Portable Oxygen (PULSEOX) - Purpose - ANSWER ✓ These composite
cylinders with attached mask can supply first aid oxygen to passenger or cabin
crew in the event of medical assistance or post-decompression.
Portable Oxygen (PULSEOX) - PFC - ANSWER ✓ b) Proper location and
secured in brackets;
c) ON-OFF switch is in the OFF position;
d) Oxygen gauge is acceptable from 1650 psi to 1850 psi;
e) To test the battery push and hold the switch. The LED illuminates GREEN to
indicate normal operation. If the light fails to illuminate, the unit is unserviceable;
and
f) Mask is attached to the cylinder.
Portable Oxygen (PULSEOX) - Duration - ANSWER ✓ Last for 180mins/ At a
rate of 4L/min
Portable Oxygen (PULSEOX) - Operation - ANSWER ✓ a) Remove mask from
the attached pouch;
b) Flip the ON-OFF switch to the ON position. The power LED will illuminate;
c) Place the mask over nose and mouth;