BMW Associate Level ASE Test 2027 Complete Questions and Guide Answers, 100% Verified Graded A+

BMW Associate Level ASE Test 2027 Complete Questions and Guide Answers, 100% Verified Graded A+ BMW special took can be used during an inspection to measure: Coolant level Coolant concentrate Brake pad thickness and tire thread depth Air pressure - ANSWER -Brake pad thickness and tire thread depth Tech A states that during a Quality Certification 1 on a G05 X5 it is necessary to press the 'AUTO' button in the light switch cluster. Tech B states that during a Quality Certification 1 on a G05 X5 you can use the same QC1 inspection sheet as a G02. - ANSWER -Both A and B If the vehicle is placed in transport mode and the vehicle battery voltage drops below 12 volts (approximately 30% State of Charge), the "Replace Battery" message will be displayed in the instrument cluster. Tech A says that charging the battery back to 100% State of Charge and clearing faults will remove the message from the instrument cluster. Tech B says that running Energy Diagnosis and clearing faults will remove the message from the instrument cluster. - ANSWER -Neither A nor B Transport Mode Switching Device can be used to successfully perform a QC1 inspection. True or False? - ANSWER -False Tech A states that on 2019 Quality Certification 1 the DOT (Department of Transportation) numbers from each tire's sidewall do not need to be recorded for factory-fitted tires. The DOT numbers were recorded at the manufacturing plant and stored in a proprietary database. Tech B states that if a BMW-approved accessory wheel set is installed by the BMW center prior to customer delivery, the DOT numbers from the accessory tires must be recorded on an individually printed QC1 checklist. - ANSWER -Both A and B Vehicle history on a specific vehicle can be retrived from DCSnet. Technician A says that the whole VIN number is required to access the information. Technician B says that only the last 7 of the VIN are required to access the information. Who is correct? - ANSWER -B Only According to MSDS warning symbols, the warning symbol with a skull and cross bones shown represents - ANSWER -Acute toxicity All of the following are true concerning the Roundtable, EXCEPT : There are 12 shows each year. Each Roundtable has a bulletin describing the topics. The Roundtable is accessed through AIR. Each Roundtable has a quiz - ANSWER -The Roundtable is accessed through AIR. The TeileClearing list is updated if needed on : The last day of the month. The 25th of each month. The 1st day of the month. The 1st day of each quarter - ANSWER -The 1st day of the month. Technician A says that SIBs can be found in TIS under Service Information. Technician B says that SIBs can be found in TIS under Technical Documentation. Who is correct? - ANSWER -A only In TMSi, what is the path to check the progress of your BMW Technical Levels? Technician A states that you can click on the Navigation Menu, select learning, view your transcript, find the tab that says BMW Technical Levels Learning Path.Then, you can either select the title BMW Technical Levels Learning Path or the Open Curriculum tab to view your transcript. Technician B states if you want to learn about finding your transcript and progress watch the 'Tech Training Graphical Learning Path' video. Who is correct? - ANSWER -A only What component is found in the Diagnostic Smoke Vapor Machine (Vacutec). - ANSWER -Pressure Regulator Which of the following is not a method of preventing hardware from loosening? - ANSWER -Flat Washer Which of the following statements is true? All aluminum fasteners are microencapsulated. All steel fasteners are reusable. A joining torque specification is the same as final torque specification. Fasteners need to stretch to get the correct holding force. - ANSWER -Fasteners need to stretch to get the correct holding force. Regarding broken bolt removal procedure. Technician A states that using cutting oil can prolong the life of the drill bit.