page? - answer balance
When slings encounter sharp edges on loads to be lifted, riggers shall ensure that slings are:
- answer protected or padded
According to asme b30.9, what is the maximum width of an object that can be placed in the
eye of a wire rope sling? - answer 1/2 the length
According to osha, the slings all fastenings and attachments shall be inspected for damage or
defects by a? - answer competent person
According to osha, alloy steel chain,wire rope, metal mesh and synthetic web slings shall not
be use with loads in excess of their ______? - answer rated capacity
According to osha, how many randomly distributed broken wires in one rope lay must there
be to remove the wire rope sling from service? - answer ten
According to osha, how many broken wires in one strand in one rope lay must there be to
remove the rope from service? - answer five
Which knot is best for tying a tagline to the eye of a sling? - answer bowline
Referring to the rigger reference booklet, what is the workload limit of wide body shackle
with pin diameter of 2.00 inches? - answer 40 tons
1
, How many randomly broken wires in six rope diameters are needed to meet the removal cri-
teria for overhead hoist? - answer 6
According asme, quadruple sling bridle ratings are the same as? - answer triple sling bri-
dle rating
According to asme b30.10, markings shell be forge, cast, or die stamped on what area of the
hook? - answer non-wearing
Referring to the rigger reference booklet, what is the capacity of 7/8 inch grade 80 alloy
chain sling using a vertical hitch? - answer 34,200
Is an overhead hoist permitted to continue operation when its wire rope reaches any one of
the removal criteria's? - answer yes, until the end of the shift with the approval of a qual-
ified person
According to asme b30.10, any hook that has any visible bend or twist from the plane of the
unbent hook shall be? - answer replaced
According to asme b30.10, any hook having distortion causing an increase in throat opening
of 5% or exceeding 1/4 , shall be? - answer replaced
According to asme b30.10, any hook having wear exceeding ________% shall be removed
from service? - answer 10%
According to osha, how often shall rigging equipment used in material handing be in-
spected? - answer prior to use each shift
2