Mike's Ultimate Mechanics Review, NEIEP Mechanics Exam Questions and Correct Answers

Mike's Ultimate Mechanics Review, NEIEP Mechanics Exam Questions and Correct Answers 1. A contractor wants to raise the car speed from 100fpm to 125fpm, it currently has a 12" sheave. What sheave is required? - Correct Answer 100fpm / 125fpm = 12" / X= 15" 2. A MOV (Metal Oxide Varistor) burns out. You replace it, but cannot read voltage or resistance. What should you do? - Correct Answer Replace it with a larger MOV 630 3. On a Ward-Leonard circuit the break is set, but the motor is trying to slip through the break. What is the issue? - Correct Answer Suicide Circuit 425 4. You have an old DC motor and are adding an SCR drive, what do you do to the interpoles? - Correct Answer Leave the interpoles alone. When adding a SCR drive to the generator, the series loop is removed, as are the 3 resistors. Everything else remains the same. 5. A hydro runs up with no load, but will not run with a full load. What is the issue? - Correct Answer The relief valve is set too low 815 6. Runby for a 1:1 hits the CWT buffer 4" below the top landing. CWT runby should be set at 18". How much should the ropes be shortened? - Correct Answer 22" 235 7. You need to work on a freight door retiring cam, you LOTO the main line but there is still power on the cam. What circuit is still hot? - Correct Answer Door Operator Disconnect/ Main Line Disconnect 535 8. The contractor requests that the vertical center of a Rack and Pinion hoist be moved. How do you do this? - Correct Answer Adjust Tie Downs and Wall Ties 850 9. Working pressure on a Hydro is 400psi. What is the maximum relief valve setting? - Correct Answer 400psi x 150%= 600psi 815 10. What must