WITH VERIFIED ANSWERS
\.Hazard or mitigation controls may be short and/or long term - ANSWERS✔-True
\.Hazard prevention and control should contain both - ANSWERS✔-Human and
administrative resources
\.A safety and health program is called a living document why - ANSWERS✔-A
safety and health program changes as an organization changes
\.What should an incident investigation program include - ANSWERS✔-All the
above
\.I'm general accidents and incidents are caused by unsafe or hazardous
conditions and - ANSWERS✔-Unsafe or unhealthy actions and behaviors
\.Who should be on the team that evaluates a safety and health program -
ANSWERS✔-All the above
\.Who should be involved in communication and coordination of safety and health
programs - ANSWERS✔-All the above
,\.Managers are considered what within an organization when it comes to safety
and health - ANSWERS✔-Agents of change
\.What is the ideal time for conducting witness interviews during an incident
investigation - ANSWERS✔-As promptly as possible since memories fade over time
\.Which of the following is an incident that should be investigated - ANSWERS✔-
All the above
\.Of the following who should be the best choice to write your organization safety
and health program - ANSWERS✔-Safety and health subject matter expert
\.You have been investigating an incident where a worker was struck in the head
by a flying scrap of wood from a table saw which of the following corrective
actions might be the most appropriate - ANSWERS✔-Table saws must always have
guards installed
\.Which of the following is a benefit for having a safety and health program -
ANSWERS✔-A company may need to bid on a contract that requires safety and
health documentation
\.When should a formal hazard assessment or inspection be performed -
ANSWERS✔-When a new hazard is uncovered
,\.Which of the following is a line role with regard to an organizations safety and
health program - ANSWERS✔-Implementing and maintaining the safety and
health program
\.Which of the following statement are true about incidents - ANSWERS✔-Nearly
all workplace incidents are wholly preventable
\.Personal fall arrest hooks must be locking and - ANSWERS✔-Designed to prevent
opening and slipping off the connector
\.Personal fall arrest system connectors must be compatible and capable of
supporting at least - ANSWERS✔-5000 pounds
\.If there are defects found during the inspection of personal fall protection
equipment or if the equipment has been used in an arrest it must be -
ANSWERS✔-Removed immediately from service
\.Three major components of personal fall arrest sustain anchor and the
anchorage connector full body harness and - ANSWERS✔-Connecting device
\.Horizontal lifelines shall be designed installed and used under the supervision of
a what as part of a complete personal fall arrest system which maintains safety
factor of at least two - ANSWERS✔-Qualified person
\.Fall restraint systems must meet which of the following criteria - ANSWERS✔-All
the above
, \.It is important to secure your ladder whenever feasible to - ANSWERS✔-Fixed
and secure points
\.OSHA and ladder manufacturers require which of the following when ascending
or descending - ANSWERS✔-3 points of contact
\.The three main types of portable ladders are - ANSWERS✔-Step straight and
extension
\.The 4:1 angle rule for extension ladders means which of the following -
ANSWERS✔-For every 4ft of the ladder it should be 1 for away from the wall
\.Protect yourself while working in a ladder by - ANSWERS✔-All the above
\.When using scaffolds make sure there is - ANSWERS✔-All the above
\.Supported scaffold systems must be inspected for - ANSWERS✔-Both b and c
\.Every supported scaffold and it's components must support without failure it's
own weight and at least what the intended load - ANSWERS✔-4 times
\.The guardrails on suspended scaffolds manufactured after the year 2000 must be
how long with mid rails installed approximately halfway between the top rail and
the platform surface - ANSWERS✔-38 and 45 inches high