When inspecting a completed cut made with oxyfuel cutting equipment, the drag
lines of the cut should be near ___ and not very pronounced
a. 3 degrees
b. 45 degrees
c. horizontal
d. vertical
Give this one a try later!
d. vertical
When lifting oxyfuel cutting cylinders, always use a(n) ___
a. sling cable
b. sling strap
c. cylinder cage
d. electromagnet
, Give this one a try later!
c. cylinder cage
A good safety practice is ___
a. welding near an open window
b. welding over wooden floors
c. to use cardboard to deflect welding / grinding sparks away from others
d. writing HOT on hot metal before leaving it unattended
Give this one a try later!
d. writing HOT on hot metal before leaving it unattended
To prevent fume hazards, there must be at least ___ cubic feet of air for each welder
a. 2,000
b. 4,000
c. 5,000
d. 10,000
Give this one a try later!
d. 10,000
The cutting tips used with liquefied fuel gases must have at least ___ preheat holes
a. four
b. five
c. six
d. seven
lines of the cut should be near ___ and not very pronounced
a. 3 degrees
b. 45 degrees
c. horizontal
d. vertical
Give this one a try later!
d. vertical
When lifting oxyfuel cutting cylinders, always use a(n) ___
a. sling cable
b. sling strap
c. cylinder cage
d. electromagnet
, Give this one a try later!
c. cylinder cage
A good safety practice is ___
a. welding near an open window
b. welding over wooden floors
c. to use cardboard to deflect welding / grinding sparks away from others
d. writing HOT on hot metal before leaving it unattended
Give this one a try later!
d. writing HOT on hot metal before leaving it unattended
To prevent fume hazards, there must be at least ___ cubic feet of air for each welder
a. 2,000
b. 4,000
c. 5,000
d. 10,000
Give this one a try later!
d. 10,000
The cutting tips used with liquefied fuel gases must have at least ___ preheat holes
a. four
b. five
c. six
d. seven
