What becomes less of a problem as the thickness of the steel being cut increases?
Give this one a try later!
Distortion
The process of cutting a groove into a surface is known as .
Give this one a try later!
gouging
What devices are often attached to the regulators, the torch, or both?
, Give this one a try later!
Flashback arrestors
When an empty cylinder has been removed from the workstation and stored, it must
be marked MT (or the acceptable site notation for indicating an empty cylinder) .
Give this one a try later!
near its top
An oxyfuel cutting torch should be checked for leaks______________ .
Give this one a try later!
each time it is used
What is the appropriate acetylene pressure for cutting 1/4" metal?
Give this one a try later!
3/5
Insufficient preheat during an oxyfuel cutting operation is likely to result in_________________
.
Give this one a try later!
Distortion
The process of cutting a groove into a surface is known as .
Give this one a try later!
gouging
What devices are often attached to the regulators, the torch, or both?
, Give this one a try later!
Flashback arrestors
When an empty cylinder has been removed from the workstation and stored, it must
be marked MT (or the acceptable site notation for indicating an empty cylinder) .
Give this one a try later!
near its top
An oxyfuel cutting torch should be checked for leaks______________ .
Give this one a try later!
each time it is used
What is the appropriate acetylene pressure for cutting 1/4" metal?
Give this one a try later!
3/5
Insufficient preheat during an oxyfuel cutting operation is likely to result in_________________
.
