OSHA 10 HOUR GENERAL INDUSTRY
FINAL EXAM 2026/2027 | VERIFIED
QUESTIONS & ANSWERS | COMPLETE
EXAM PREP | GRADED A+ | 100%
CORRECT | GUARANTEED PASS
1. The mission of the Occupational Safety and Health Administration (OSHA)
is: - ANSWER To send every worker home whole and healthy every day
2. Electricity travels in closed circuits, and its normal route is through a
conductor. Electric shock occurs when: - ANSWER Your body becomes
part of the circuit
3. What are two US government agencies that are good resources for safety
and health information? - ANSWER OSHA and NIOSH
4. OSHA requires fall protection when working near the edge of a trench or
excavation that is _________ or more in depth. - ANSWER 6 feet
5. Every supported scaffold and its components must support, without failure,
its own weight and at least _______ the intended load. - ANSWER 4
times
,6. During an OSHA inspection: - ANSWER You have the right to talk to the
inspector privately
7. The OSHA standards for Construction and General Industry are found in: -
ANSWER Parts 1926 and 1910
8. When the employer receives an OSHA citation, it must be: -
ANSWER Posted for 3 days or until the violation is fixed
9. What does OSHA require employers to post for 3 days? -
ANSWER OSHA citations and abatement verification notices
10.What section of the OSH Act does the Whistleblower Program reference? -
ANSWER Section 11(c)
11.OSHA requires fall protection at different heights for construction and
general industry however, regardless of the fall distance, which of the
following is most - ANSWER A. Fall protection must be provided when
working over dangerous equipment
B. Fall protection must be provided when working over dangerous machinery
C. Both A and B are correct
D. None of the above
12.Employees must not work on scaffold surfaces until: - ANSWER It is
determined to have strength and structural integrity to support intended loads
,13.From your choices below, what would you consider to be a "major" fall
hazard in construction? - ANSWER A. Roof edges and floor openings
B. Steel erection
C. Improper scaffold construction
D. Unsafe use of portable ladders
E. All the above
14.Climbing on the cross braces of scaffolds is allowed: - ANSWER Never
15.If there are defects found during the inspection of personal fall protection
equipment, or if the equipment has been used in an arrest, it must be: -
ANSWER Removed immediately from service
16.More than 33% of fatalities in construction are from a combination of falls
from: - ANSWER Roofs
17.Examples of fall hazards that have resulted in deaths on the jobsite include: -
ANSWER A. Falls to the ground or lower levels
B. Falls through existing floor or roof openings C. Falls through the floor or
roof surface
D. Falls on the same level
E. All the above
18.How can YOU prevent a fall from a ladder? - ANSWER A. Choose the
right ladder for the job
B. Tie the top and bottom of the ladder to fixed points when necessary
C. Don't carry tools or other materials in-hand while climbing the ladder
D. All the above
, 19.Three major components of a Personal Fall Arrest System (PFAS) include;
anchor and the anchorage connector; full body harness; and: -
ANSWER Connecting device (lanyard with shock absorber/retractable
lifeline, snap hooks)
20.When using scaffolds, make sure there is which of the following? -
ANSWER A. Safe and compliant access and egress
B. Full planking
C. Stable footing
D. Guard railing
E. All of the above
21.Preventing fall hazards is a critical part of the construction planning process.
Controls to mitigate fall hazards include installing which of the following? -
ANSWER A. Guardrails
B. Walls
C. Protective covers
D. Parapets
E. All of the above
22.OSHA requires fall protection at different heights for construction and
general industry however, regardless of the fall distance, which of the
following is most correct? - ANSWER A. Fall protection must be
provided when working over dangerous equipment
B. Fall protection must be provided when working over dangerous
machinery
C. Both A and B are correct
D. None of the above
FINAL EXAM 2026/2027 | VERIFIED
QUESTIONS & ANSWERS | COMPLETE
EXAM PREP | GRADED A+ | 100%
CORRECT | GUARANTEED PASS
1. The mission of the Occupational Safety and Health Administration (OSHA)
is: - ANSWER To send every worker home whole and healthy every day
2. Electricity travels in closed circuits, and its normal route is through a
conductor. Electric shock occurs when: - ANSWER Your body becomes
part of the circuit
3. What are two US government agencies that are good resources for safety
and health information? - ANSWER OSHA and NIOSH
4. OSHA requires fall protection when working near the edge of a trench or
excavation that is _________ or more in depth. - ANSWER 6 feet
5. Every supported scaffold and its components must support, without failure,
its own weight and at least _______ the intended load. - ANSWER 4
times
,6. During an OSHA inspection: - ANSWER You have the right to talk to the
inspector privately
7. The OSHA standards for Construction and General Industry are found in: -
ANSWER Parts 1926 and 1910
8. When the employer receives an OSHA citation, it must be: -
ANSWER Posted for 3 days or until the violation is fixed
9. What does OSHA require employers to post for 3 days? -
ANSWER OSHA citations and abatement verification notices
10.What section of the OSH Act does the Whistleblower Program reference? -
ANSWER Section 11(c)
11.OSHA requires fall protection at different heights for construction and
general industry however, regardless of the fall distance, which of the
following is most - ANSWER A. Fall protection must be provided when
working over dangerous equipment
B. Fall protection must be provided when working over dangerous machinery
C. Both A and B are correct
D. None of the above
12.Employees must not work on scaffold surfaces until: - ANSWER It is
determined to have strength and structural integrity to support intended loads
,13.From your choices below, what would you consider to be a "major" fall
hazard in construction? - ANSWER A. Roof edges and floor openings
B. Steel erection
C. Improper scaffold construction
D. Unsafe use of portable ladders
E. All the above
14.Climbing on the cross braces of scaffolds is allowed: - ANSWER Never
15.If there are defects found during the inspection of personal fall protection
equipment, or if the equipment has been used in an arrest, it must be: -
ANSWER Removed immediately from service
16.More than 33% of fatalities in construction are from a combination of falls
from: - ANSWER Roofs
17.Examples of fall hazards that have resulted in deaths on the jobsite include: -
ANSWER A. Falls to the ground or lower levels
B. Falls through existing floor or roof openings C. Falls through the floor or
roof surface
D. Falls on the same level
E. All the above
18.How can YOU prevent a fall from a ladder? - ANSWER A. Choose the
right ladder for the job
B. Tie the top and bottom of the ladder to fixed points when necessary
C. Don't carry tools or other materials in-hand while climbing the ladder
D. All the above
, 19.Three major components of a Personal Fall Arrest System (PFAS) include;
anchor and the anchorage connector; full body harness; and: -
ANSWER Connecting device (lanyard with shock absorber/retractable
lifeline, snap hooks)
20.When using scaffolds, make sure there is which of the following? -
ANSWER A. Safe and compliant access and egress
B. Full planking
C. Stable footing
D. Guard railing
E. All of the above
21.Preventing fall hazards is a critical part of the construction planning process.
Controls to mitigate fall hazards include installing which of the following? -
ANSWER A. Guardrails
B. Walls
C. Protective covers
D. Parapets
E. All of the above
22.OSHA requires fall protection at different heights for construction and
general industry however, regardless of the fall distance, which of the
following is most correct? - ANSWER A. Fall protection must be
provided when working over dangerous equipment
B. Fall protection must be provided when working over dangerous
machinery
C. Both A and B are correct
D. None of the above
