MICHIGAN STATE BRAKES CERTIFICATION
QUESTIONS & ANSWERS PASSED 100%
1. Most 1995 & newer vehicles use
Sealed non-serviceable
which of the following types of
wheels bearings on non-drive
wheel?
2. to test a vacuum power brake booster in the drop slightly and remain firm
vehicle, you should pump the brake
ped-al at least 4 times, hold the
brake pedal depressed, and start the
engine. the brake pedal should:
3. You are installing a set of brake shoe linings Smaller and goes towards the
front of the
that are not the same length. car.
Traditionally, the primary shoe lining
is:
hard pedal feel requiring very high pedal
4. A cracked or torn vacuum ettort to stop
diaphragm in a brake power booster
would most likely cause:
master cylinder push rod adjusted too long
5. Which of the following incorrect
service procedures will cause
brake lock-up?
6. Which of the following describes the proper Pump the brake pedal at least
25 times
way to depressurized an ABS likely cause is the:
system?
8. On a 3-channel
system, which wheels
7. The rear brakes are dragging after are on the same
having new linings installed and circuit?
the drums ma-chined. the most
1/
7
, MICHIGAN STATE BRAKES CERTIFICATION
QUESTIONS & ANSWERS PASSED 100%
or more, depending on the manufacturer's recommendation) stuck
with the ignition ott.
echnician use the parking brake to adjust shoes and the cable isboth rear wheels
9. wheel speed sensors
2/
7
QUESTIONS & ANSWERS PASSED 100%
1. Most 1995 & newer vehicles use
Sealed non-serviceable
which of the following types of
wheels bearings on non-drive
wheel?
2. to test a vacuum power brake booster in the drop slightly and remain firm
vehicle, you should pump the brake
ped-al at least 4 times, hold the
brake pedal depressed, and start the
engine. the brake pedal should:
3. You are installing a set of brake shoe linings Smaller and goes towards the
front of the
that are not the same length. car.
Traditionally, the primary shoe lining
is:
hard pedal feel requiring very high pedal
4. A cracked or torn vacuum ettort to stop
diaphragm in a brake power booster
would most likely cause:
master cylinder push rod adjusted too long
5. Which of the following incorrect
service procedures will cause
brake lock-up?
6. Which of the following describes the proper Pump the brake pedal at least
25 times
way to depressurized an ABS likely cause is the:
system?
8. On a 3-channel
system, which wheels
7. The rear brakes are dragging after are on the same
having new linings installed and circuit?
the drums ma-chined. the most
1/
7
, MICHIGAN STATE BRAKES CERTIFICATION
QUESTIONS & ANSWERS PASSED 100%
or more, depending on the manufacturer's recommendation) stuck
with the ignition ott.
echnician use the parking brake to adjust shoes and the cable isboth rear wheels
9. wheel speed sensors
2/
7
