TEST–CRM QUESTIONS & CORRECT
ANSWERS
1. What adjustment is to be made after a tie
a) Toe
rod end is replaced?
a) Toe
b) Caster
c)Camber
d) No adjustment needed
2. An Air Conditioning system should not be left d) moisture may enter
open to the atmosphere for extended periods the system and cause
because? corro- sion
a) Once opened to the atmosphere it cannot
be re- sealed
b) it is almost impossible to purge air from
the evapo- rator
c)Air will damage the reed values in the
compressor
d)moisture may enter the system and cause d) The exhaust
corrosion system is
3. A vehicle has had front and undercarriage
damage.
After repairs are completed the car starts, but ha little restricted
power. What could be the cause?
a) The oil pan has been crushed so that the oil
pump cannot pick up oil
b) The torque converter bolts have been sheared
c)the transmission shift linkage is disconnected
d) The exhaust system is restricted
,MICHIGAN MECHANIC LICENSE PRACTICE
TEST–CRM QUESTIONS & CORRECT
ANSWERS
4. After collision repairs are performed, a clunking c) broken motor
noise can be hard in the engine compartment mounts
upon acceler- ation. What could be the most
likely cause?
a) Sheared torque convertor bolts
, MICHIGAN MECHANIC LICENSE PRACTICE
TEST–CRM QUESTIONS & CORRECT
ANSWERS
b) a restricted exhaust system
c)broken motor mounts
d) A bent oil pan
5. A car equipped with an automatic b) Check the shift level
transmission has been hit in the rear end. linkage
Now the car moves even though the selector
level is in park. What should you do first?
a) Replace the transmission
b) Check the shift level linkage
c)replace the differential
d) Install a new torque convertor
6. If you remove a transaxle from front wheel b) Be careful not to dam-
drive car, you should, age the axle boots
a) Install a new transmission mount
b) Be careful not to damage the axle boots
c)Install a new drive belt
d) All of the above
7. After a repair, the starter will not crank the engine fast d) Charge
the battery
enough to start. What should you do first?
a) Replace the battery
b) Replace the starter
c)Disconnect the electric control module and try again
d) Charge the battery