NEIEP 515 PIPING AND WIRING THE CAR QUESTIONS
WITH VERIFIED ANSWERS
One-half - Answers - The Loop that is formed in the traveling cables at _______ the
speed of the car
Bracketing attached to the guide rail, the hoistway wall, or the building structure -
Answers - The stationary end of the traveling cable is fastened to _______, _______, or
_______
Signal - Answers - Each wire carries a specific electrical ________ between the car and
the machine room controls
Strain wire - Answers - The steel core is called the _______
Reduce friction and enhance flexibility - Answers - Jute fibers are included to _______
and _______
Torsional stress - Answers - Before they are permanently installed, traveling cables
should be hung free in order to relieve _______
Spool - Answers - On Lengths up to 100 feet _______ supports may be used
200 Feet - Answers - On lengths over _______ the strain wire must be used for
suspension
Junction box - Answers - At the permanent suspension point in the hoistway, slightly
above the center of travel, an electrical _______ may be installed
200 - Answers - Cable grippers may be used to suspend up to _______ feet of traveling
cable
Controller - Answers - On a low-rise installation, such as a hydraulic elevator, the
traveling cables may run to the _______
Fully compressed buffer - Answers - On a high rise elevator with a deep pit, the
reference point for the lop in the traveling cable will be above the pit floor, where the car
rests on the _______
Reel rollers, reel jacks, saw horses - Answers - When the traveling cable is received on
reels, the reels can be set up on _______, _______, _______
Split cable gripper and swivel link - Answers - When raising traveling cables with a
hoisting line, the line should be connected with a _______
WITH VERIFIED ANSWERS
One-half - Answers - The Loop that is formed in the traveling cables at _______ the
speed of the car
Bracketing attached to the guide rail, the hoistway wall, or the building structure -
Answers - The stationary end of the traveling cable is fastened to _______, _______, or
_______
Signal - Answers - Each wire carries a specific electrical ________ between the car and
the machine room controls
Strain wire - Answers - The steel core is called the _______
Reduce friction and enhance flexibility - Answers - Jute fibers are included to _______
and _______
Torsional stress - Answers - Before they are permanently installed, traveling cables
should be hung free in order to relieve _______
Spool - Answers - On Lengths up to 100 feet _______ supports may be used
200 Feet - Answers - On lengths over _______ the strain wire must be used for
suspension
Junction box - Answers - At the permanent suspension point in the hoistway, slightly
above the center of travel, an electrical _______ may be installed
200 - Answers - Cable grippers may be used to suspend up to _______ feet of traveling
cable
Controller - Answers - On a low-rise installation, such as a hydraulic elevator, the
traveling cables may run to the _______
Fully compressed buffer - Answers - On a high rise elevator with a deep pit, the
reference point for the lop in the traveling cable will be above the pit floor, where the car
rests on the _______
Reel rollers, reel jacks, saw horses - Answers - When the traveling cable is received on
reels, the reels can be set up on _______, _______, _______
Split cable gripper and swivel link - Answers - When raising traveling cables with a
hoisting line, the line should be connected with a _______
