MASTER ELECTRICIAN FINAL EXAM SCRIPT
COMPLETE QUESTIONS AND CORRECT
ANSWERS VERIFIED PASS
●● Knife switch rated for more than 1200 Amps at 250Volts or less.
Answer: Can be used only as isolating switch, shall not be opened under
load
●● Track lighting with outlets in a bathroom is not allowed because ?.
Answer: Track lighting has receptacle
●● Where internal combustion engines are used as the prime motor, an
on site fuel supply shall be provided with an on premise fuel supply
sufficient for not less than ____ hours full demand operation of the
system.
Answer: 6 hours
●● Fixed in place X-ray equipment properly supplied by a branch circuit
rated at not over ____ amperes shall be permitted to be supplied through
a suitable attachment plug cap and hard service cable cord..
Answer: 30 Amps
,●● Where skin effect exist the ferromagnetic envelope shall be bonded
at ____..
Answer: Both ends
●● GFCI protection at a carnival is not required for equipment at circuit
if the receptacle is of the ____type..
Answer: Locking
●● The maximum voltage drop from service point to the last over-
current device in a dwelling unit?.
Answer: 4%
●● Which of the following statements best describe the grounding
requirement for central vacuum outlet.
Answer: Accessible non current carrying metal parts are required to be
connected to an equipment grounding conductor.
●● In healthcare facilities, patient bed receptacles located in general care
areas shall be supplied by at least two branch circuits, which
____permitted to originate from two separate transfer switches on the
emergency system.
Answer: Are permitted
,●● Patient care areas of healthcare facilities ____ areas such as business
offices, corridors, lounges ,day rooms, or similar areas.
Answer: Do not include
●● The patient care area is any portion of the healthcare facility where
patients are intended to be ____or ____..
Answer: Examined or treated
●● Each general care area patient bed location in a healthcare facility
must be provided with four ____ or ____ duplex receptacles.
Answer: Single or two
●● A hospital is a building or portion thereof used for medical,
psychiatric,obstetrical , or surgical, care on a 24 hour basis of ____ or
more patients.
Answer: Four
●● Where installed to reduce electrical noise for electronic equipment,
electrical continuity of the metal raceways shall not be required and
metal raceway can terminate a (an) ____ nonmetallic fitting or spacer on
electronic equipment.
Answer: Listed fitting
, ●● Feeder and branch circuit conductors within ____ inches of a Ballast
shall have an insulation temperature rating not lower than 90°C (194°F)
unless supplying a luminaiere marked as suitable for a different
insulation temperature.
Answer: 3 inches
●● Manufactured wiring systems constructed with type MC cable shall
be supported and secured at intervals not exceeding ____ ft..
Answer: 6 ft
●● Where a main bonding jumper or a system bonding jumper is a
screw only the screw shall be identified with a ____ that shall be visible
with the screw installed.
Answer: Green finish
●● Plug fuses a 15 amperes and lower rating shall be identified by a
____ configuration of the window, cap, or other prominent part to
distinguish them from fuses of higher ampere rating.
Answer: Hexagon
●● The load for household electric clothes dryer's in a dwelling unit(s)
shall be either ____ watts (volt-amperes) or the nameplate rating, which
ever is larger, for each dryer served ?.
Answer: 5000 watts
COMPLETE QUESTIONS AND CORRECT
ANSWERS VERIFIED PASS
●● Knife switch rated for more than 1200 Amps at 250Volts or less.
Answer: Can be used only as isolating switch, shall not be opened under
load
●● Track lighting with outlets in a bathroom is not allowed because ?.
Answer: Track lighting has receptacle
●● Where internal combustion engines are used as the prime motor, an
on site fuel supply shall be provided with an on premise fuel supply
sufficient for not less than ____ hours full demand operation of the
system.
Answer: 6 hours
●● Fixed in place X-ray equipment properly supplied by a branch circuit
rated at not over ____ amperes shall be permitted to be supplied through
a suitable attachment plug cap and hard service cable cord..
Answer: 30 Amps
,●● Where skin effect exist the ferromagnetic envelope shall be bonded
at ____..
Answer: Both ends
●● GFCI protection at a carnival is not required for equipment at circuit
if the receptacle is of the ____type..
Answer: Locking
●● The maximum voltage drop from service point to the last over-
current device in a dwelling unit?.
Answer: 4%
●● Which of the following statements best describe the grounding
requirement for central vacuum outlet.
Answer: Accessible non current carrying metal parts are required to be
connected to an equipment grounding conductor.
●● In healthcare facilities, patient bed receptacles located in general care
areas shall be supplied by at least two branch circuits, which
____permitted to originate from two separate transfer switches on the
emergency system.
Answer: Are permitted
,●● Patient care areas of healthcare facilities ____ areas such as business
offices, corridors, lounges ,day rooms, or similar areas.
Answer: Do not include
●● The patient care area is any portion of the healthcare facility where
patients are intended to be ____or ____..
Answer: Examined or treated
●● Each general care area patient bed location in a healthcare facility
must be provided with four ____ or ____ duplex receptacles.
Answer: Single or two
●● A hospital is a building or portion thereof used for medical,
psychiatric,obstetrical , or surgical, care on a 24 hour basis of ____ or
more patients.
Answer: Four
●● Where installed to reduce electrical noise for electronic equipment,
electrical continuity of the metal raceways shall not be required and
metal raceway can terminate a (an) ____ nonmetallic fitting or spacer on
electronic equipment.
Answer: Listed fitting
, ●● Feeder and branch circuit conductors within ____ inches of a Ballast
shall have an insulation temperature rating not lower than 90°C (194°F)
unless supplying a luminaiere marked as suitable for a different
insulation temperature.
Answer: 3 inches
●● Manufactured wiring systems constructed with type MC cable shall
be supported and secured at intervals not exceeding ____ ft..
Answer: 6 ft
●● Where a main bonding jumper or a system bonding jumper is a
screw only the screw shall be identified with a ____ that shall be visible
with the screw installed.
Answer: Green finish
●● Plug fuses a 15 amperes and lower rating shall be identified by a
____ configuration of the window, cap, or other prominent part to
distinguish them from fuses of higher ampere rating.
Answer: Hexagon
●● The load for household electric clothes dryer's in a dwelling unit(s)
shall be either ____ watts (volt-amperes) or the nameplate rating, which
ever is larger, for each dryer served ?.
Answer: 5000 watts
