QUESTIONS AND CORRECT ANSWERS
what is the resistance of the terminating resistor on networks equipped with one
start connector? - Correct Answer 60 ohms
with the bus active and no faults present, what voltages should be measured on
CAN-C(+)? - Correct Answer approximately 3.2v
what Atlantis-high network uses splice block connectors? - Correct Answer
CAN-BH
with the bus active and no faults present, what voltages should be measured on
CAN-B(-)? - Correct Answer approximately 0.4v
which resource should be used first for troubleshooting DRB III Emulator
concerns? - Correct Answer wiTECH knowledge base
with the bus active and no faults present, what voltages should be measured on
LIN? - Correct Answer 7.0v-10.0v