NCCER MILLWRIGHT PRACTICE EXAM 2 |
Questions with 100% Correct Answers | Verified |
Latest Update 2026
Save
Practice questions for this set
Learn 1 /7 Study using Learn
high
Choose an answer
If the seal was not properly aligned
Positive results in an offset
or there is excessive wear in some
1 2 measurement mean that the MTBM is
bearing or shaft,_______ wear tracks will
_____ or on the 3-o'clock side.
be the indicator
When applying sealant to the sealing
gland flanges, keep the sealant away The orthographic drawing may
3 4
from the inside edges of the flange contain a dashed or _______ line
by at least_______ inch
Don't know?
, Terms in this set (136)
If the seal was not properly aligned unusual
or there is excessive wear in some
bearing or shaft,_______ wear tracks will
be the indicator
For removing hard to remove gasket sharpened brass putty knife
materials found on sealing surfaces,
______ is recommended
Apprenticeship training is_______ Conducted on the job
Charting alignment on a graph distance
requires a chart that is divided into
thousandths of an inch vertically for
the indicator readings and into
whole inches horizontally for
the__________
The orthographic drawing may hidden
contain a dashed or _______ line
In order to shoot through a test Radiation
object and project an image onto a
detector or a sheet of film,
radiography uses a source of
penetrating called _______
Which of the following task would *scribe circles
you not perform with dividers? *transfer measurements
*compare distances
<measure angles
Questions with 100% Correct Answers | Verified |
Latest Update 2026
Save
Practice questions for this set
Learn 1 /7 Study using Learn
high
Choose an answer
If the seal was not properly aligned
Positive results in an offset
or there is excessive wear in some
1 2 measurement mean that the MTBM is
bearing or shaft,_______ wear tracks will
_____ or on the 3-o'clock side.
be the indicator
When applying sealant to the sealing
gland flanges, keep the sealant away The orthographic drawing may
3 4
from the inside edges of the flange contain a dashed or _______ line
by at least_______ inch
Don't know?
, Terms in this set (136)
If the seal was not properly aligned unusual
or there is excessive wear in some
bearing or shaft,_______ wear tracks will
be the indicator
For removing hard to remove gasket sharpened brass putty knife
materials found on sealing surfaces,
______ is recommended
Apprenticeship training is_______ Conducted on the job
Charting alignment on a graph distance
requires a chart that is divided into
thousandths of an inch vertically for
the indicator readings and into
whole inches horizontally for
the__________
The orthographic drawing may hidden
contain a dashed or _______ line
In order to shoot through a test Radiation
object and project an image onto a
detector or a sheet of film,
radiography uses a source of
penetrating called _______
Which of the following task would *scribe circles
you not perform with dividers? *transfer measurements
*compare distances
<measure angles
