Millwright Test | Questions with 100% Correct
Answers | Verified | Latest Update 2026
Save
Terms in this set (213)
If the seal was not properly aligned Unusual
or there is excessive wear in some
bearing or shaft______ wear tracks will
be the indicator.
For removing hard to remove gasket sharpened brass putty knife
materials found on sealing surfaces
______ is recommended.
Apprenticeship training is Conducted on the job
Charting alignment on a graph Distance
requires a chart that is divided into
thousandths of an inch vertically for
the indicator readings and into
whole inches horizontally for the
_______ measurements.
The orthographic drawing may Hidden
contain a dash or ______ line
, In order to shoot through a test Radiation
object and project an image onto a
detector sheet or film radiography
used as a source of penetrating _____.
Which of the following task would Measure angles
you not perform with dividers?
The overspeed trip device is 10
actuated when the turbine reaches a
predetermined limit usually _______
percent above normal full load
speed
Positive results in an offset High
measurement mean that the MTBM is
______ or on the 3 o'clock side
Coupling gap is set and then there is Offset misalignment
measured
In a hydraulic system movement Pressure
depends on
Fractional dimensions are used on Such as furniture or utility items
objects ____
If the cause of the problem is not Elimination
immediately understood the process
of _____ is often the procedure of
choice
Answers | Verified | Latest Update 2026
Save
Terms in this set (213)
If the seal was not properly aligned Unusual
or there is excessive wear in some
bearing or shaft______ wear tracks will
be the indicator.
For removing hard to remove gasket sharpened brass putty knife
materials found on sealing surfaces
______ is recommended.
Apprenticeship training is Conducted on the job
Charting alignment on a graph Distance
requires a chart that is divided into
thousandths of an inch vertically for
the indicator readings and into
whole inches horizontally for the
_______ measurements.
The orthographic drawing may Hidden
contain a dash or ______ line
, In order to shoot through a test Radiation
object and project an image onto a
detector sheet or film radiography
used as a source of penetrating _____.
Which of the following task would Measure angles
you not perform with dividers?
The overspeed trip device is 10
actuated when the turbine reaches a
predetermined limit usually _______
percent above normal full load
speed
Positive results in an offset High
measurement mean that the MTBM is
______ or on the 3 o'clock side
Coupling gap is set and then there is Offset misalignment
measured
In a hydraulic system movement Pressure
depends on
Fractional dimensions are used on Such as furniture or utility items
objects ____
If the cause of the problem is not Elimination
immediately understood the process
of _____ is often the procedure of
choice
