FINAL ELEVATOR ACTUAL EXAM
PAPER 2026 QUESTIONS WITH
ANSWERS GRADED A+
◍ electron current flow.
Answer: The uniform movement of electrons from the negative terminal to
the positive terminal when a difference of potential is applied across a wire
◍ which statement best describes magnetic lines of force?.
Answer: never cross one another
◍ ASME.
Answer: American Society of Mechanical Engineers
◍ which of the following statements is correct about lines of magnetic force?.
Answer: they flow internally within a magnet from south to north
◍ DOSH.
Answer: Division of Occupational Safety and Health
◍ LADBS.
Answer: Los Angeles Department of Building and Safety
◍ Alteration made to conveyance shall comply with ASME A17.1-204
Section.
Answer: 8.7
◍ which of the following is true for parallel circuits?.
Answer: the total circuit current will be equal to the product of the branch
currents
◍ The seismic section of ASME A17.1-2004 and alterations made to
conveyances must also comply with this section.
Answer: 8.4
,◍ which of the following is considered a good insulator?.
Answer: rubber
◍ when many loops of wire have current flowing through them, what do they
form?.
Answer: coil
◍ What must be submitted to the applicable Division Elevator office prior to
beginning construction or alterations on a conveyance Title 8 Sec 3000.
Answer: Letter of Intent
◍ When shall Category One Tests on conveyances be completed Title 8 Sec
3141.6.
Answer: Once every 12 months
◍ What shall be provided on all conveyances regardless of the existence of an
emergency stop switchASME A17.1-2004 2.27.1.2.
Answer: Audible signaling device
◍ if circuit resistance is doubled what is the effect of circuit current?.
Answer: the current will be halved
◍ When are Hoistway door unlocking devices on all conveyances
requiredTitle 8 Sec 3141.7ASME A17.1-20042.12.6.
Answer: Prohibited
◍ what is the average value of an AC sine wave alternation with a peak value
of 135 volts?.
Answer: 85.86 volts
◍ What section should Group IV platform lifts and stairway chairlifts shall
comply with.
Answer: ASME A18.1-2003
◍ When using a rotating field to generate electricity, where is the output
voltage taken from to supply the load?.
Answer: the stator
, ◍ before attempting to measure the resistance of an unknown resistor in a
circuit what must be done?.
Answer: remove power and disconnect both resistor leads to isolate the
resistor
◍ what is the wattage developed from an AC voltage with a peak value of 120
volts across a 80 ohm resistor?.
Answer: 180 watts
◍ a coulomb equals 6,240,000,000,000,000,000 electrons. express in scientific
notation..
Answer: 6.24 x 10 ^18
◍ When setbacks or projections exceed this number of inches, occur in the
enclosure wall, the top of the setback or projection shall be beveled at an
angle not less than 75 degrees with the horizontal ASME A17.1-20042.1.6.
Answer: 4 inches
◍ In which direction does electron current flow?.
Answer: negative to positive
◍ with a voltage source of 90 VDC and a current of 90 mA, what is the circuit
resistance?.
Answer: 1 K ohms
◍ What is the total current drawn from a source that supplies 120 volts to the
ten 60 watt lamps?.
Answer: 0.5 ampsI = p/eI= 120/60I= .5 A
◍ which of the following formulas is correct for finding power in watts?.
Answer: P = E x I
◍ Thermistors possess which of the following qualities?.
Answer: As their temperature changes their resistance changes
◍ what does it mean when saturation occurs?.
Answer: no more magnetic lines can be produced
◍ what is true of voltage in a series circuit?.
PAPER 2026 QUESTIONS WITH
ANSWERS GRADED A+
◍ electron current flow.
Answer: The uniform movement of electrons from the negative terminal to
the positive terminal when a difference of potential is applied across a wire
◍ which statement best describes magnetic lines of force?.
Answer: never cross one another
◍ ASME.
Answer: American Society of Mechanical Engineers
◍ which of the following statements is correct about lines of magnetic force?.
Answer: they flow internally within a magnet from south to north
◍ DOSH.
Answer: Division of Occupational Safety and Health
◍ LADBS.
Answer: Los Angeles Department of Building and Safety
◍ Alteration made to conveyance shall comply with ASME A17.1-204
Section.
Answer: 8.7
◍ which of the following is true for parallel circuits?.
Answer: the total circuit current will be equal to the product of the branch
currents
◍ The seismic section of ASME A17.1-2004 and alterations made to
conveyances must also comply with this section.
Answer: 8.4
,◍ which of the following is considered a good insulator?.
Answer: rubber
◍ when many loops of wire have current flowing through them, what do they
form?.
Answer: coil
◍ What must be submitted to the applicable Division Elevator office prior to
beginning construction or alterations on a conveyance Title 8 Sec 3000.
Answer: Letter of Intent
◍ When shall Category One Tests on conveyances be completed Title 8 Sec
3141.6.
Answer: Once every 12 months
◍ What shall be provided on all conveyances regardless of the existence of an
emergency stop switchASME A17.1-2004 2.27.1.2.
Answer: Audible signaling device
◍ if circuit resistance is doubled what is the effect of circuit current?.
Answer: the current will be halved
◍ When are Hoistway door unlocking devices on all conveyances
requiredTitle 8 Sec 3141.7ASME A17.1-20042.12.6.
Answer: Prohibited
◍ what is the average value of an AC sine wave alternation with a peak value
of 135 volts?.
Answer: 85.86 volts
◍ What section should Group IV platform lifts and stairway chairlifts shall
comply with.
Answer: ASME A18.1-2003
◍ When using a rotating field to generate electricity, where is the output
voltage taken from to supply the load?.
Answer: the stator
, ◍ before attempting to measure the resistance of an unknown resistor in a
circuit what must be done?.
Answer: remove power and disconnect both resistor leads to isolate the
resistor
◍ what is the wattage developed from an AC voltage with a peak value of 120
volts across a 80 ohm resistor?.
Answer: 180 watts
◍ a coulomb equals 6,240,000,000,000,000,000 electrons. express in scientific
notation..
Answer: 6.24 x 10 ^18
◍ When setbacks or projections exceed this number of inches, occur in the
enclosure wall, the top of the setback or projection shall be beveled at an
angle not less than 75 degrees with the horizontal ASME A17.1-20042.1.6.
Answer: 4 inches
◍ In which direction does electron current flow?.
Answer: negative to positive
◍ with a voltage source of 90 VDC and a current of 90 mA, what is the circuit
resistance?.
Answer: 1 K ohms
◍ What is the total current drawn from a source that supplies 120 volts to the
ten 60 watt lamps?.
Answer: 0.5 ampsI = p/eI= 120/60I= .5 A
◍ which of the following formulas is correct for finding power in watts?.
Answer: P = E x I
◍ Thermistors possess which of the following qualities?.
Answer: As their temperature changes their resistance changes
◍ what does it mean when saturation occurs?.
Answer: no more magnetic lines can be produced
◍ what is true of voltage in a series circuit?.
