CAN B CAN FD LIN Bus Automotive Ethernet
Atlantis High SGW wiTECH Diagnostics Voltage
Testing Termination Resistance PROXI
Configuration Fault Diagnosis Loss of
Communication Test Network Troubleshooting
Exam Questions Verified and Provided with
Complete A+ Graded Answers Latest Updated 2026
what is the resistance of the terminating resistor on networks equipped with one start
connector?
60 ohms
with the bus active and no faults present, what voltages should be measured on CAN-C(+)?
approximately 3.2v
what Atlantis-high network uses splice block connectors?
CAN-BH
, with the bus active and no faults present, what voltages should be measured on CAN-B(-)?
approximately 0.4v
which resource should be used first for troubleshooting DRB III Emulator concerns?
wiTECH knowledge base
with the bus active and no faults present, what voltages should be measured on LIN?
7.0v-10.0v
what electrical architecture requires the use of the mopar diagnostic pod (MPD) for diagnostics?
Atlantis-high
which of the following scan tool functions ate prevented if a security gateway (SGW) becomes
locked? select all that apply.
start an actuator
run a system test
flash program a module
with the bus active and no faults present, what voltages should be measured on CAN-C(-)?
approximately 1.8v