EVITP Questions and Answers

EVITP Questions and Answers A partial zero emissions vehicle (PZEV) is defined as which of the following? A gas-engined vehicle that has zero evaporative emissions from its fuel system The state of charge is the available capacity of the battery, expressed as a percentage. True Which of the following is not an alternative to fossil fuels? Gasoline The EV industry is comprised of..? Auto manufacturers, consumer advocacy groups, EV charging equipment manufacturers, research and standards organizations The first electric vehicle can be traced back to...? 1832 Which of the following illustrates why electric vehicles were so popular in the early days of automobiles? They were mechanically complicated, they were quiet What factors limited the popularity of EV's as internal combustion engine vehicles came to the market in the early 1900s? Charing times, range, speed What was the first mass- produced hybrid electric vehicle? Toyota Prius What improvements in technology have increased interest in EV's? Improved range, power and lighter batteries What best describes early EV's Quiet, easy to start and mechanically simple Which of the following is not a category of electric vehicles? ICE What category of EV has been available to consumers the longest? HEV Which of the following describes a plug in electric vehicle that runs on batteries until nearly depleted, then switches over to an ICE generator to extend the battery range? PHEV A battery electric vehicle requires external charging but does not rely on an internal combustion generator for extended range True EVs can be equipped with a(n) ? motor. induction and permanent magnet Regenerative braking is best described by which of the following? An energy recovery system Which of the following describes an EV drivetrain architecture in which power can be transmitted to the drive from two sources at the same time? Parallel hybrid drive What types of commercial/industrial vehicles are currently available in an electrified version? cargo and material handling equipment, delivery vans and buses, semi trailers trucks Forklifts, yard tractors and drayage trucks are all examples of? Cargo handling equipment Charging methods for battery electric buses include which of the following? above/below bus charging wireless charging, plug in charging, wireless power transfer L2: Charging is defined as which of the following? Supplying power to an EV battery L2:Which of the following acronyms represents the level of charge present in an EV battery? SOC L2:Electric vehicle supply equipment (EVSE) provides which of the following safety features? GFCI protection and hardware fault detection L2:EVSE provides DC power to the electric vehicle charging port. False L2:DC charging equipment provides DC directly to ...?... in an EV. Battery management System L2:The Society of Auto Engineers (SAE) creates standards for which of the following? Maximum current voltage specifications for EVSE, Plug configuration safety features L2:An AC charger with a single-phase 120-volt connection and 14-16 amperes of continuous current output is classified as a ..?... charger. Level 1 L2:An AC charger with a single-phase 208-volt or 240-volt connection and a continuous current output of up to 80 amperes is classified as a ....?.. charger. Level 2 L2: The purpose of the J1772 connector pins is to provide ...?... a charging interface that is safe for consumers to use, a means to signal the EVSE to stop charging based on the pin contact state, signals to the EVSE that the connector is properly seated on the vehicle L2:Which of the following is true about the J1772 standard control pilot terminal pin's function? It changes to the state of the EVSE according to the voltage present, it defines the state of the EVSE. It uses a +12V to -12V Ac square wave signal L2:Which of the following is not a variable that determines the charging time of an EV? Connector configuration L2:The EV's power acceptance rate should not be considered when making EVSE purchasing decisions. False L2:The State of Charge of the EV battery is ...?... a determining factor in calculating the time necessary to fully charge an EV L2:Which of the following is the Japanese Dx quick charging standard? ChAdeMO L2: The ChAdeMO V1.0 Standard has charging power up to ...?... at ..?...., up to ...?.. 62.5kW /500 VDC/ 125 A L2: Wireless EV charging utilizes the principles of ...?... Induction L2: Which of the following is connected to the change of a wireless EV charger via hardwiring? Power source coil L2: What are the advantages of wireless charging? It has no exposed electrical contact points and wireless charging has better aesthetic quality L2: Wireless charging is more expensive than coupled EVSE. True L2: What is the SAE standard for wireless charging? J2954 recommended practice L2: The SAE standard for wireless charging has specifications that include which of the following? Magnetic triangulation for vehicle alignment over the power source coil, means to allow for payment without physical interaction, up to 11kW charging capacity L2: Which of the following is not true of EV charging networks? None of the above L2: EV networks utilize memberships that are ? . fee-based or pay-as-you-go L2: EV networks generate revenue with which of the following? call to pay, membership fees, station usage fees L3: The national Electrical Code (NEC)? Provides minimum installation requirements L3: Installations covered by the NEC include which of the following? industrial substations, installations on public and private premises, recreational vehicles, floating buildings and mobile homes L3: NEC chapters 1-4 apply to ...?.. All installations except as modified by CH's 5, 6, and 7 L3: NEC chapter 8 covers ...?... systems and ..?.. subject to chapters 1-7 unless specifically referenced. communications/ is not Chapter 9 of the NEC contains which of the following? Tables that are applicable and enforceable when referenced elsewhere in the code Definitions that are specific to a particular article are located in which of the following sections? xxx.2 Article 110 covers ..?.. requirements for wiring and equipment. General