Oregon Tattoo Test 2026| Answered 100% correctly

Oregon Tattoo Test 2026| Answered 100% correctly When the armature bar is flat on the front coil, what is the smallest gap above the rear coil? .010 What does a smaller gap above the rear coil cause? More power What should armature bars be made of? plain steel How does a machine run if too much of the coil core is showing? hot What type of edges should your contact screw have? rounded and smooth Where on the front spring should the contact screw be hitting? Front or End of spring What length of spring would run faster? short spring with a high angle What type of metal should the contact screw be made of to have the highest conductivity? brass How does the armature bar hit the front coil core? flat full contact What do you want the frame on your tattoo machine to be? non-conductive What happens when your machine is conductive or electrified? The armature bar sticks to the coils causing the machine to stay in an "on" setting What diameter should your binding post be? 5/16 What happens if you use a steel contact screw? Can cause unwanted spark When setting up your machine, why would you "snug" down the eye of the needle bar? This helps to prevent weak and jumpy lines Why is a one-piece contact screw the best choice? Screws with things added on top can add to the vibration What are the two advantages to using a brass contact screw? 100% conductive and keeps its shape longer than other choices How much of the contact screw needs to be touching the front spring? A tiny contact area Why should you use plain steel for a spring rather than a coated spring?