VEHICLE MANAGEMENT SYSTEMS
QUESTIONS AND ANSWERS
If an oxygen sensor indicates an AFR(rich AFR) which could cause the condition? - ans-
sd sd sd sd sd sd sd sd sd sd sd sd sd sdsd
High Fuel System Pressure sd sd sd
Which OBDII codes signify an Idle Control Circuit - ans-P0505
sd sd sd sd sd sd sd sd sdsd
While manually performing an OBDII drive cycle test, which system will be tested during 2 1
sd sd sd sd sd sd sd sd sd sd sd sd sd sd sd
/2 mins if idling after start? - ans-
sd sd sd sd sd sd sdsd
Canister Purge, O2 system and Cat Converter will be tested later because it require heat to
sd sd sd sd sd sd sd sd sd sd sd sd sd sd sd sd
properly read the system. sd sd sd
OBD II equipped vehicle has MIL but will not communicate with the scan tool. What would c
sd sd sd sd sd sd sd sd sd sd sd sd sd sd sd sd
ause the issue? - ans-Non-compliant CAN scan tool
sd sd sd sdsd sd sd sd
Which publication contains procedures for retrieving diagnostic trouble trees? - ans-
sd sd sd sd sd sd sd sd sd sdsd
Service Manual sd
Which on board controllers should be checked for information on the power window? - ans-
sd sd sd sd sd sd sd sd sd sd sd sd sd sdsd
BCM
On boad diagnostic system publishes U0029, Vehicle communication Bus a Performance,
sd sd sd sd sd sd sd sd sd sd sd
which tool should you use to test networking wiring? - ans-High Speed Lab Scope
sd sd sd sd sd sd sd sd sd sdsd sd sd sd
In order to replace a splayed pin on a PCM harness, which of the following should be used?
sd sd sd sd sd sd sd sd sd sd sd sd sd sd sd sd sd
- ans-Terminal Tool
sd sdsd sd
OBD II protocol ensures that an MIL will illuminate when tailpipe emission exceed Federal
sd sd sd sd sd sd sd sd sd sd sd sd sd sd
Test procedures by what %? - ans-50% higher or 1 1/2 times the limit
sd sd sd sd sd sdsd sd sd sd sd sd sd sd
In order to properly start a drive cycle test to verify a system fix, what should the ECT be les
sd sd sd sd sd sd sd sd sd sd sd sd sd sd sd sd sd sd sd
s than? - ans-50*C or 122*F
sd sd sdsd sd sd
If the active suspension were to incur a fault, what would be the generated code start with a
sd sd sd sd sd sd sd sd sd sd sd sd sd sd sd sd sd
n OBD II - ans-C for Chassis
sd sd sd sdsd sd sd
V8, OBD compliant hesitate a few mins after a hot soak restart condition and then runs fine,
sd sd sd sd sd sd sd sd sd sd sd sd sd sd sd sd s
which sensor is more likely to cause this condition? - ans-Oxygen sensor
d sd sd sd sd sd sd sd sd sd sdsd sd
QUESTIONS AND ANSWERS
If an oxygen sensor indicates an AFR(rich AFR) which could cause the condition? - ans-
sd sd sd sd sd sd sd sd sd sd sd sd sd sdsd
High Fuel System Pressure sd sd sd
Which OBDII codes signify an Idle Control Circuit - ans-P0505
sd sd sd sd sd sd sd sd sdsd
While manually performing an OBDII drive cycle test, which system will be tested during 2 1
sd sd sd sd sd sd sd sd sd sd sd sd sd sd sd
/2 mins if idling after start? - ans-
sd sd sd sd sd sd sdsd
Canister Purge, O2 system and Cat Converter will be tested later because it require heat to
sd sd sd sd sd sd sd sd sd sd sd sd sd sd sd sd
properly read the system. sd sd sd
OBD II equipped vehicle has MIL but will not communicate with the scan tool. What would c
sd sd sd sd sd sd sd sd sd sd sd sd sd sd sd sd
ause the issue? - ans-Non-compliant CAN scan tool
sd sd sd sdsd sd sd sd
Which publication contains procedures for retrieving diagnostic trouble trees? - ans-
sd sd sd sd sd sd sd sd sd sdsd
Service Manual sd
Which on board controllers should be checked for information on the power window? - ans-
sd sd sd sd sd sd sd sd sd sd sd sd sd sdsd
BCM
On boad diagnostic system publishes U0029, Vehicle communication Bus a Performance,
sd sd sd sd sd sd sd sd sd sd sd
which tool should you use to test networking wiring? - ans-High Speed Lab Scope
sd sd sd sd sd sd sd sd sd sdsd sd sd sd
In order to replace a splayed pin on a PCM harness, which of the following should be used?
sd sd sd sd sd sd sd sd sd sd sd sd sd sd sd sd sd
- ans-Terminal Tool
sd sdsd sd
OBD II protocol ensures that an MIL will illuminate when tailpipe emission exceed Federal
sd sd sd sd sd sd sd sd sd sd sd sd sd sd
Test procedures by what %? - ans-50% higher or 1 1/2 times the limit
sd sd sd sd sd sdsd sd sd sd sd sd sd sd
In order to properly start a drive cycle test to verify a system fix, what should the ECT be les
sd sd sd sd sd sd sd sd sd sd sd sd sd sd sd sd sd sd sd
s than? - ans-50*C or 122*F
sd sd sdsd sd sd
If the active suspension were to incur a fault, what would be the generated code start with a
sd sd sd sd sd sd sd sd sd sd sd sd sd sd sd sd sd
n OBD II - ans-C for Chassis
sd sd sd sdsd sd sd
V8, OBD compliant hesitate a few mins after a hot soak restart condition and then runs fine,
sd sd sd sd sd sd sd sd sd sd sd sd sd sd sd sd s
which sensor is more likely to cause this condition? - ans-Oxygen sensor
d sd sd sd sd sd sd sd sd sd sdsd sd