The Ohm's Law formula for calculating voltage is __________.
Give this one a try later!
E=I(current)*R(resistance)
The power is connected to a single phase motor using __________ lines.
Give this one a try later!
2
,An off delay timer contact __________.
Give this one a try later!
energizes when the timer is activated and deenergizes when the timer times
out
What is not considered one of the five basic components of a hydraulic system?
Give this one a try later!
pressure
In the calculation of shaft speed and shaft torques of a belt drive system, which of the
following applies?
Give this one a try later!
shaft speeds are inversely proportional to pitch diameters
The type of current that only flows in one direction is __________.
Give this one a try later!
DC
,The sprocket ratio for a chain drive system having a driven sprocket with 54 teeth and
a driver sprocket with 18 teeth is __________.
Give this one a try later!
3
A magnaflux test is used to show what flaw in ferrous metal?
Give this one a try later!
Cracks in the surface
Compared to a V-belt drive, a chain drive __________.
Give this one a try later!
is more efficient
The 3-way DCV spool is held in the energized position by the __________.
Give this one a try later!
operator
, Smaller dirt particles are removed from the air by the filter's __________.
Give this one a try later!
element
When using the __________ in welding, the electrode should be leaned 15 to 25 degrees
in the direction of travel.
Give this one a try later!
pull technique
A __________ can show when DHC of a filter has been reached.
Give this one a try later!
bypass indicator
In the United States, oil viscosity is measured in __________.
Give this one a try later!
Saybolt Universal Seconds
Give this one a try later!
E=I(current)*R(resistance)
The power is connected to a single phase motor using __________ lines.
Give this one a try later!
2
,An off delay timer contact __________.
Give this one a try later!
energizes when the timer is activated and deenergizes when the timer times
out
What is not considered one of the five basic components of a hydraulic system?
Give this one a try later!
pressure
In the calculation of shaft speed and shaft torques of a belt drive system, which of the
following applies?
Give this one a try later!
shaft speeds are inversely proportional to pitch diameters
The type of current that only flows in one direction is __________.
Give this one a try later!
DC
,The sprocket ratio for a chain drive system having a driven sprocket with 54 teeth and
a driver sprocket with 18 teeth is __________.
Give this one a try later!
3
A magnaflux test is used to show what flaw in ferrous metal?
Give this one a try later!
Cracks in the surface
Compared to a V-belt drive, a chain drive __________.
Give this one a try later!
is more efficient
The 3-way DCV spool is held in the energized position by the __________.
Give this one a try later!
operator
, Smaller dirt particles are removed from the air by the filter's __________.
Give this one a try later!
element
When using the __________ in welding, the electrode should be leaned 15 to 25 degrees
in the direction of travel.
Give this one a try later!
pull technique
A __________ can show when DHC of a filter has been reached.
Give this one a try later!
bypass indicator
In the United States, oil viscosity is measured in __________.
Give this one a try later!
Saybolt Universal Seconds
