The dial indicator makes measurements using the ______ method.
Give this one a try later!
indirect comparison
The three standard views of an object are ______.
Give this one a try later!
top, front, right side
,A ______ dimension is described in inches per foot.
Give this one a try later!
shaft taper
Parts labeled ______ should be inspected to determine if they should be reworked or
scrapped.
Give this one a try later!
hold
Metals treated by ______ processes become soft.
Give this one a try later!
annealing
A running fit is also called a(n) ______.
Give this one a try later!
sliding fit
, The typical accuracy of a dial caliper is about ______ inches.
Give this one a try later!
0.003
Companies typically include policies and procedures for continuous improvement as
part of their______.
Give this one a try later!
quality assurance system
A micrometer increments how far for each complete rotation of its thimble?
Give this one a try later!
0.025
The term ______ refers to a physical portion of a part.
Give this one a try later!
feature
Give this one a try later!
indirect comparison
The three standard views of an object are ______.
Give this one a try later!
top, front, right side
,A ______ dimension is described in inches per foot.
Give this one a try later!
shaft taper
Parts labeled ______ should be inspected to determine if they should be reworked or
scrapped.
Give this one a try later!
hold
Metals treated by ______ processes become soft.
Give this one a try later!
annealing
A running fit is also called a(n) ______.
Give this one a try later!
sliding fit
, The typical accuracy of a dial caliper is about ______ inches.
Give this one a try later!
0.003
Companies typically include policies and procedures for continuous improvement as
part of their______.
Give this one a try later!
quality assurance system
A micrometer increments how far for each complete rotation of its thimble?
Give this one a try later!
0.025
The term ______ refers to a physical portion of a part.
Give this one a try later!
feature
