HVAC 102 BASIC ELECTRICITY FINAL EXAM Newest 2026
Complete Questions and Correct Detailed Answers
(Verified Answers) |Already Graded A+
Leave the first rating
Save
Students also studied
Flashcard sets Study guides
Outboard 2 & 4 Final Exam Review 4th Class ABSA Exam Part A Practic... CUSP - T&D C-2
Teacher 141 terms Teacher 942 terms Teacher 151 terms Te
ain_G Preview rodriguezyasley2 Preview Eric_Musyoka7 Preview
Terms in this set (50)
1. Which can replace a 220 volt 20 MFD capacitor D. None of the above (All options don't make sense) (microfarads can't differ
from replacement?)
2. When hooking up a transformer that has multiple capped off with wire buts individually. Preventing shorts
primary leads for different voltages the unused leads
would be ________.
3. If a circuit breaker or fuse trips immediately upon direct short to ground
power, most likely________
4. When replacing a half horse motor with another half check the amp draw and speed of the motor
horse motor _________
WHEN RUNNING A 208-230v motor ________ A. should be 208 - 230 volts
6. The reason for having a resistor solder to a start It will bleed off the wattage and keep the motor from workin too hard
capacitor terminal is so _________
7. The purpose of a megohmmeter is to________. can help to find places in the windings where the insulation is getting weak
The biggest advantage of an ECM motor is that _______ It can change its speed in response to what it senses in the system.
A split phase motor has a ____ winding and a _____ Start, run
winding.
The Back EMF of a motor is ________ all the above (induced in start winding, voltage is higher than applied voltage,
used to operate a potential relay
Complete Questions and Correct Detailed Answers
(Verified Answers) |Already Graded A+
Leave the first rating
Save
Students also studied
Flashcard sets Study guides
Outboard 2 & 4 Final Exam Review 4th Class ABSA Exam Part A Practic... CUSP - T&D C-2
Teacher 141 terms Teacher 942 terms Teacher 151 terms Te
ain_G Preview rodriguezyasley2 Preview Eric_Musyoka7 Preview
Terms in this set (50)
1. Which can replace a 220 volt 20 MFD capacitor D. None of the above (All options don't make sense) (microfarads can't differ
from replacement?)
2. When hooking up a transformer that has multiple capped off with wire buts individually. Preventing shorts
primary leads for different voltages the unused leads
would be ________.
3. If a circuit breaker or fuse trips immediately upon direct short to ground
power, most likely________
4. When replacing a half horse motor with another half check the amp draw and speed of the motor
horse motor _________
WHEN RUNNING A 208-230v motor ________ A. should be 208 - 230 volts
6. The reason for having a resistor solder to a start It will bleed off the wattage and keep the motor from workin too hard
capacitor terminal is so _________
7. The purpose of a megohmmeter is to________. can help to find places in the windings where the insulation is getting weak
The biggest advantage of an ECM motor is that _______ It can change its speed in response to what it senses in the system.
A split phase motor has a ____ winding and a _____ Start, run
winding.
The Back EMF of a motor is ________ all the above (induced in start winding, voltage is higher than applied voltage,
used to operate a potential relay
