CSWA Simulation EXAM Questions & Answers,
Well Elaborated | Already Verified Test |100%
Verified solutions |2026 Latest!!
Save
Practice questions for this set
Learn 1 /7 Study with Learn
Terms in this set (67)
h-method of meshing involves increasing mesh density
p-method of meshing involves increasing mesh element polynomial order
is it possible to model breaking of no
glass on the floor using linear static
analysis?
which of the following cases, the both are the same
rope will most likely break?
, Assuming a linear static study, if the doubles
Young's modulus of the material is
doubles (everything else remains
the same), then the tensile stress
will be
iso lot in the simulation will enable set lower and upper limits to see desired stress
to range
which statement best describes a a mesh where elements on touching bodies have
compatible mesh? overlaying nodes
maximum and minimum value true
indicators are displayed on stress
and displacement plots in
SOLIDWORKS simulation for a
linear static study
what SOLIDWORKS simulation tool probe tool
should you use to determine the
result values at specific locations
(nodes) in a model using
SOLIDWORKS simulation?
what criteria are best suited to maximum von Mises stress and maximum shear
check the failure of ductile stress criterion
materials in SOLIDWORKS
simulation?
what is the modulus of elasticity? the slope of the stress-strain curve in its linear
section
what is stress? a measure of average amount of force exerted
per unit area
Well Elaborated | Already Verified Test |100%
Verified solutions |2026 Latest!!
Save
Practice questions for this set
Learn 1 /7 Study with Learn
Terms in this set (67)
h-method of meshing involves increasing mesh density
p-method of meshing involves increasing mesh element polynomial order
is it possible to model breaking of no
glass on the floor using linear static
analysis?
which of the following cases, the both are the same
rope will most likely break?
, Assuming a linear static study, if the doubles
Young's modulus of the material is
doubles (everything else remains
the same), then the tensile stress
will be
iso lot in the simulation will enable set lower and upper limits to see desired stress
to range
which statement best describes a a mesh where elements on touching bodies have
compatible mesh? overlaying nodes
maximum and minimum value true
indicators are displayed on stress
and displacement plots in
SOLIDWORKS simulation for a
linear static study
what SOLIDWORKS simulation tool probe tool
should you use to determine the
result values at specific locations
(nodes) in a model using
SOLIDWORKS simulation?
what criteria are best suited to maximum von Mises stress and maximum shear
check the failure of ductile stress criterion
materials in SOLIDWORKS
simulation?
what is the modulus of elasticity? the slope of the stress-strain curve in its linear
section
what is stress? a measure of average amount of force exerted
per unit area
