FLT410: TEXTBOOK QUESTIONS
TURBINES TEST 3 QUESTIONS
COMPLETE WITH VERIFIED ANSWERS
\.Two categories of engine operating procedures are - ANSWERS-
Normal and Emergency
\.Purging of an engine is done to - ANSWERS-Remove fuel vapors from
the engine
\.When restarting an engine in flight what is not normally needed? -
ANSWERS-The ignition
\.Before shut down the engine should be run 20 to 30 seconds at idle to
- ANSWERS-Stabilize component temps
\.Wet takeoff Power - ANSWERS-Engine operations in water injection
mode
\.Dry takeoff power - ANSWERS-Engine operations without water
injection mode
, \.Maximum cruise power rating has no - ANSWERS-Time limit
\.Two most important cockpit gauges are - ANSWERS-RPM and EGT
\.Climb and cruise power settings are selected by way of fan speed, -
ANSWERS-EPR or torque
\.The reason that rpm must be allowed to stabilize prior to shut down is
to prevent uneven _____ in the hot section - ANSWERS-Cooling
\.What would a shut down procedure without a stabilizing period at idle
lead to? - ANSWERS-An incorrect oil tank level
\.Line maintenance refers to inspection and repair of turbine engines
while they are - ANSWERS-A flight line aircraft
\.FOD can occur when debris in sucked in from the - ANSWERS-Ground
\.Compressor field cleaning restores the aerodynamic shape or surface
of compressor - ANSWERS-Blades and vanes
TURBINES TEST 3 QUESTIONS
COMPLETE WITH VERIFIED ANSWERS
\.Two categories of engine operating procedures are - ANSWERS-
Normal and Emergency
\.Purging of an engine is done to - ANSWERS-Remove fuel vapors from
the engine
\.When restarting an engine in flight what is not normally needed? -
ANSWERS-The ignition
\.Before shut down the engine should be run 20 to 30 seconds at idle to
- ANSWERS-Stabilize component temps
\.Wet takeoff Power - ANSWERS-Engine operations in water injection
mode
\.Dry takeoff power - ANSWERS-Engine operations without water
injection mode
, \.Maximum cruise power rating has no - ANSWERS-Time limit
\.Two most important cockpit gauges are - ANSWERS-RPM and EGT
\.Climb and cruise power settings are selected by way of fan speed, -
ANSWERS-EPR or torque
\.The reason that rpm must be allowed to stabilize prior to shut down is
to prevent uneven _____ in the hot section - ANSWERS-Cooling
\.What would a shut down procedure without a stabilizing period at idle
lead to? - ANSWERS-An incorrect oil tank level
\.Line maintenance refers to inspection and repair of turbine engines
while they are - ANSWERS-A flight line aircraft
\.FOD can occur when debris in sucked in from the - ANSWERS-Ground
\.Compressor field cleaning restores the aerodynamic shape or surface
of compressor - ANSWERS-Blades and vanes
