1|Page
CNMI Road Sign / Traffic Signal Technician
Certification Exam Practice Questions And Correct
Answers||Verified Exam!!|| (Verified Answers) Plus
Rationales 2026/2027 Q&A | Instant Download Pdf
Which of the following is NOT a sentence type in the
MUTCD?
Standards; requirement that have to be followed.
Guidance; recommendations that are to be followed
unless there I good reason not to.
Objectives; reasons behind the standards and guidance.
Support; additional information to clarify the standards and
guidance. - Answer-Objectives; reasons behind the
standards and guidance
Which of the following is an example configuration fo an
Emergency - Vehicle Traffic Control Signals? - Answer-
Thee section traffic signal with circular red, circular yellow,
and smaller circular yellow indications.
The following phases are typically assigned to the major-
street through movements: - Answer-2 and 6
,2|Page
There green interval is made up of which three
components? - Answer-Minimum green, passage time,
maximum green
What are the three typical types of recall features of a
traffic signal controller? - Answer-Minimum, Maximum,
Pedestrian
What is the primary function of the IMAS? - Answer-Safety
Education
IMSA Stands for - Answer-International Municipal Signal
Association
Which of the following is NOT an IMSA certification? -
Answer-Traffic Signal Level III Bridge Technician
Which of the following are potential safety hazards? -
Answer-overhead and underground power, gas, aerial lift
equipment. Tra
What are the sections of a ramp mete signal - Answer-
Circular red, circular green
,3|Page
PPE stands for - Answer-Personal Protective Equipment
A work zone supervisor is responsible for which of the
following tasks: - Answer-Ensure advance warning devices
have not been removed or relocated.
In a coordination plan, what is the number of seconds
given to each phase at the intersection? - Answer-split
which of the following traffic signal coordination methods is
typically the least expensive? - Answer-Time-Based
Coordination
Which of the following is a definition for cycle length? -
Answer-The elapsed time between the start of a specific
display until that display comes up again.
Which of the following is a characteristic of sequential
phases? - Answer-they cannot occur at the same time.
Which of the following is a definition for initial green time -
Answer-Minimum time that that the green indication myst
be displayed
, 4|Page
The only point in the cycle of a coordinated traffic signal
controller where the major street phase is allowed to end
is called - Answer-Yield point
Which of ht following is NOT a common mode of operation
for timing plans in a signal system? - Answer-Traffic
Related
Two common terms to describe traffic signal supports and
signal heads are - Answer-rigid and free-swinging
IN a single wire with. single point attachment
configuration, the wire that supports the signal heads is
called the - Answer-Messenger Wire
The two nominal diameter sizes for vehicular signal lenses
are: - Answer-8 in (200mm) and 12 in (300mm)
The purpose of "Louvers" is to: - Answer-make signal
visible from a specific lane
CNMI Road Sign / Traffic Signal Technician
Certification Exam Practice Questions And Correct
Answers||Verified Exam!!|| (Verified Answers) Plus
Rationales 2026/2027 Q&A | Instant Download Pdf
Which of the following is NOT a sentence type in the
MUTCD?
Standards; requirement that have to be followed.
Guidance; recommendations that are to be followed
unless there I good reason not to.
Objectives; reasons behind the standards and guidance.
Support; additional information to clarify the standards and
guidance. - Answer-Objectives; reasons behind the
standards and guidance
Which of the following is an example configuration fo an
Emergency - Vehicle Traffic Control Signals? - Answer-
Thee section traffic signal with circular red, circular yellow,
and smaller circular yellow indications.
The following phases are typically assigned to the major-
street through movements: - Answer-2 and 6
,2|Page
There green interval is made up of which three
components? - Answer-Minimum green, passage time,
maximum green
What are the three typical types of recall features of a
traffic signal controller? - Answer-Minimum, Maximum,
Pedestrian
What is the primary function of the IMAS? - Answer-Safety
Education
IMSA Stands for - Answer-International Municipal Signal
Association
Which of the following is NOT an IMSA certification? -
Answer-Traffic Signal Level III Bridge Technician
Which of the following are potential safety hazards? -
Answer-overhead and underground power, gas, aerial lift
equipment. Tra
What are the sections of a ramp mete signal - Answer-
Circular red, circular green
,3|Page
PPE stands for - Answer-Personal Protective Equipment
A work zone supervisor is responsible for which of the
following tasks: - Answer-Ensure advance warning devices
have not been removed or relocated.
In a coordination plan, what is the number of seconds
given to each phase at the intersection? - Answer-split
which of the following traffic signal coordination methods is
typically the least expensive? - Answer-Time-Based
Coordination
Which of the following is a definition for cycle length? -
Answer-The elapsed time between the start of a specific
display until that display comes up again.
Which of the following is a characteristic of sequential
phases? - Answer-they cannot occur at the same time.
Which of the following is a definition for initial green time -
Answer-Minimum time that that the green indication myst
be displayed
, 4|Page
The only point in the cycle of a coordinated traffic signal
controller where the major street phase is allowed to end
is called - Answer-Yield point
Which of ht following is NOT a common mode of operation
for timing plans in a signal system? - Answer-Traffic
Related
Two common terms to describe traffic signal supports and
signal heads are - Answer-rigid and free-swinging
IN a single wire with. single point attachment
configuration, the wire that supports the signal heads is
called the - Answer-Messenger Wire
The two nominal diameter sizes for vehicular signal lenses
are: - Answer-8 in (200mm) and 12 in (300mm)
The purpose of "Louvers" is to: - Answer-make signal
visible from a specific lane
