BCTC INDUSTRIAL MAINTENANCE
TECHNOLOGY AMTEC CERTIFICATION TEST
PAPER 2026 COMPLETE SOLUTIONS GRADED
A PLUS
◉ If you were asked to check out the I/O card on a plc, which card
would you look at?
Answer: Input Card
◉ What does the term current refer to while dealing with
electricity?
Answer: Amps
◉ On a hydraulic pump if you were told the pump is cavitating, what
would you check for?
Answer: Low fluid in the tank
◉ In a 480 volt three phase system, what would your meter read if
you went from one leg to ground?
Answer: 277
◉ WHICH TOOL IS USED WHEN MEASURING SCREW PITCH
, Answer: Thread Gauge
◉ What is a circuit breaker?
Answer: an automatically operated electrical switch designed to
protect an electrical circuit from damage caused by overload or
short circuit.
◉ What does a D.P.S.T. switch refer to?
Answer: double pole single throw
◉ How many teeth are on a 40B12 sprocket?
Answer: 12
◉ The BCD equivalent of 1247 converts to_____.
Answer: 0001 0010 0100 0111
◉ What is the binary value of the following terms: Word and Nibble
Answer: 16 digit and 4 digit
◉ What type of programming is used by PLCs.
Answer: ladder logic
TECHNOLOGY AMTEC CERTIFICATION TEST
PAPER 2026 COMPLETE SOLUTIONS GRADED
A PLUS
◉ If you were asked to check out the I/O card on a plc, which card
would you look at?
Answer: Input Card
◉ What does the term current refer to while dealing with
electricity?
Answer: Amps
◉ On a hydraulic pump if you were told the pump is cavitating, what
would you check for?
Answer: Low fluid in the tank
◉ In a 480 volt three phase system, what would your meter read if
you went from one leg to ground?
Answer: 277
◉ WHICH TOOL IS USED WHEN MEASURING SCREW PITCH
, Answer: Thread Gauge
◉ What is a circuit breaker?
Answer: an automatically operated electrical switch designed to
protect an electrical circuit from damage caused by overload or
short circuit.
◉ What does a D.P.S.T. switch refer to?
Answer: double pole single throw
◉ How many teeth are on a 40B12 sprocket?
Answer: 12
◉ The BCD equivalent of 1247 converts to_____.
Answer: 0001 0010 0100 0111
◉ What is the binary value of the following terms: Word and Nibble
Answer: 16 digit and 4 digit
◉ What type of programming is used by PLCs.
Answer: ladder logic
