BMW ASE LEVEL 1 | UESTIONS AND ANSWERS |
LATEST QUIZ
Save
Terms in this set (93)
Two technicians are discussing Technician B
voltage drop:
Technician A states that voltage drop
is the amount of voltage used by the
battery.
Technician B states that voltage drop
is the amount of voltage needed to
push current through a resistance.
Who's is correct?
When testing for source voltage, the DC voltage
DVOM should be set to:
AC voltage
DC voltage
AC amp
DC amp
Two technicians are discussing the KL Both
terminals:
Technician A states that KL30
indicates hot all times
Technician B states KL31indcates a
permanent ground.
Who's correct?
,When installing a new battery in a Register the new battery
BMW, with the same capacity, we
need to:
Register the new battery
Register and retrofit the new battery
Program the vehicle for the new
battery
None of the above.
ALL the following statements are Vehicle needs to be in PAD mode
correct when installing a V-cable to
a module, EXCEPT:
The vehicle must be in KL0.
Vehicle has to be at sleep.
Vehicle needs to be in PAD mode
Battery should be disconnected.
All these checks should be Meter leads should be tested for no less than 1Ω of
performed when using a DVOM, resistance
EXCEPT:
Check the meter's battery
Visual inspection of the leads
Meter leads should be tested for no
less than 1Ω of resistance
Check the meter's internal fuses
Two technicians are discussing an Both
electrical diagnostic process,
Technician A states that for you to
diagnoses an electrical problem an
ABL should be performed.
Technician B states the technician, if
needed can find the correct SSP
inside the ABL.
Who's correct?
, Two technicians are discussing the Technician B
pin assignment chart:
Technician A states that the letter E
stands for Electrical
Technician B states that the letter E
stands for Input.
Who's correct?
BMW recommends that an AGM 12.5 V
battery's SOC never drops below?
12.5 V
12.0 V
13.1 V
11.0 V
Two technicians are discussing Technician A
removing a battery cable.
Technician A states that BMW
recommends the technician waits for
the vehicle to go to sleep before
disconnecting the cable.
Technician B states that once the key
is removed from the vehicle it is safe
to remove the battery cable.
Who's correct?
Two technicians are discussing Technician A
Available voltage:
Technician A states that available
voltage should be within .3v of
source voltage.
Technician B states that available
voltage should be within 1v of source
voltage.
Who's correct?
LATEST QUIZ
Save
Terms in this set (93)
Two technicians are discussing Technician B
voltage drop:
Technician A states that voltage drop
is the amount of voltage used by the
battery.
Technician B states that voltage drop
is the amount of voltage needed to
push current through a resistance.
Who's is correct?
When testing for source voltage, the DC voltage
DVOM should be set to:
AC voltage
DC voltage
AC amp
DC amp
Two technicians are discussing the KL Both
terminals:
Technician A states that KL30
indicates hot all times
Technician B states KL31indcates a
permanent ground.
Who's correct?
,When installing a new battery in a Register the new battery
BMW, with the same capacity, we
need to:
Register the new battery
Register and retrofit the new battery
Program the vehicle for the new
battery
None of the above.
ALL the following statements are Vehicle needs to be in PAD mode
correct when installing a V-cable to
a module, EXCEPT:
The vehicle must be in KL0.
Vehicle has to be at sleep.
Vehicle needs to be in PAD mode
Battery should be disconnected.
All these checks should be Meter leads should be tested for no less than 1Ω of
performed when using a DVOM, resistance
EXCEPT:
Check the meter's battery
Visual inspection of the leads
Meter leads should be tested for no
less than 1Ω of resistance
Check the meter's internal fuses
Two technicians are discussing an Both
electrical diagnostic process,
Technician A states that for you to
diagnoses an electrical problem an
ABL should be performed.
Technician B states the technician, if
needed can find the correct SSP
inside the ABL.
Who's correct?
, Two technicians are discussing the Technician B
pin assignment chart:
Technician A states that the letter E
stands for Electrical
Technician B states that the letter E
stands for Input.
Who's correct?
BMW recommends that an AGM 12.5 V
battery's SOC never drops below?
12.5 V
12.0 V
13.1 V
11.0 V
Two technicians are discussing Technician A
removing a battery cable.
Technician A states that BMW
recommends the technician waits for
the vehicle to go to sleep before
disconnecting the cable.
Technician B states that once the key
is removed from the vehicle it is safe
to remove the battery cable.
Who's correct?
Two technicians are discussing Technician A
Available voltage:
Technician A states that available
voltage should be within .3v of
source voltage.
Technician B states that available
voltage should be within 1v of source
voltage.
Who's correct?
