FAL TFM12 BFAT0 UPDATED ACTUAL QUESTIONS AND CORRECT ANSWERS
If exit doors are unlocked by the fire alarm system, the before activation of the public notification appliances in the area
unlocking function shall occur
at the same time as the activation of the public notification appliances in that area
Fire Alarm system wiring, equipment and circuits NFPA 70 National Electrical Code Article 760
controlled and powered by the fire alarm system shall be
installed in accordance with the requirements of
NFPA 72 in the 2013 edition is also known as National Fire Alarm and Signaling Code
Which document below classifies occupancy addresses NFPA 101 Life Safety Code
the minimum acceptable attributes of a fire alarm system
based on the occupancy classification
The gas cooking equipment extinguisher system in a 17A
commercial restaurant is most commonly regulated by
which standard?
Which code or standard covers the application, NFPA 72, National Fire Alarm and Signaling Code
installation, performance, and maintenance of fire alarm
systems and their components?
Foams also are defined by expansion and are arbitrarily expansion up to 1000 x original volume
subdivided into three ranges of expansion low, medium,
and high. High expansion foam exhibits
, A circuit breaker that serves as the primary power source Have its location permanently identified at the Fire Alarm Control Unit
disconnect means for a Fire Alarm Control Unit is
required to, Supply no other loads other than those dedicated to the fire alarm or ECS
Have a permanent red marking that does not obscure the manufacturers marking
A system that permits the operator to acknowledge an Positive Alarm Sequence
alarm signal, and investigate for up to 180 seconds before
automatically evacuating the building, is equipped with
which feature below?
An audible or visible signal conveying more than one Coded
discrete bit of information
The maximum number of waterflow detection devices 5
permitted to be connected to a single Initiating Device
Circuit in a Protected Premises System?
"When it operates, the temperature of the surrounding air Fixed Temperature
will always be higher than the rated temperature of the
device itself"; describes which device below
A single element spot-type detector which may; inhibit Rate of Rise
contact closure until the total device has been heated to
its rated temperature or; close its contacts on a fast rate-
of-temperature rise even if the device has not yet
reached the rated temperature
Spot type Heat Sensing Fire Detectors mounted on the Not less than 4 inches form the sidewall
ceiling shall be
For Fire Alarm systems "Cu" is the standard abbreviation Copper as in copper wire
used for
True or False: The purpose of NFPA 70 is the practical False
safeguarding of persons and property from hazards
arising from the use of electricity and does NOT regulate
the neatness of an installation
A device that senses visible or invisible particles of Smoke Detector
combustion
Select the detector and operating principle most Ionization Smoke Detector
appropriate to detect thin gaseous products of
combustion and nearly invisible particulate matter .01
micron to .3 micron in size
If exit doors are unlocked by the fire alarm system, the before activation of the public notification appliances in the area
unlocking function shall occur
at the same time as the activation of the public notification appliances in that area
Fire Alarm system wiring, equipment and circuits NFPA 70 National Electrical Code Article 760
controlled and powered by the fire alarm system shall be
installed in accordance with the requirements of
NFPA 72 in the 2013 edition is also known as National Fire Alarm and Signaling Code
Which document below classifies occupancy addresses NFPA 101 Life Safety Code
the minimum acceptable attributes of a fire alarm system
based on the occupancy classification
The gas cooking equipment extinguisher system in a 17A
commercial restaurant is most commonly regulated by
which standard?
Which code or standard covers the application, NFPA 72, National Fire Alarm and Signaling Code
installation, performance, and maintenance of fire alarm
systems and their components?
Foams also are defined by expansion and are arbitrarily expansion up to 1000 x original volume
subdivided into three ranges of expansion low, medium,
and high. High expansion foam exhibits
, A circuit breaker that serves as the primary power source Have its location permanently identified at the Fire Alarm Control Unit
disconnect means for a Fire Alarm Control Unit is
required to, Supply no other loads other than those dedicated to the fire alarm or ECS
Have a permanent red marking that does not obscure the manufacturers marking
A system that permits the operator to acknowledge an Positive Alarm Sequence
alarm signal, and investigate for up to 180 seconds before
automatically evacuating the building, is equipped with
which feature below?
An audible or visible signal conveying more than one Coded
discrete bit of information
The maximum number of waterflow detection devices 5
permitted to be connected to a single Initiating Device
Circuit in a Protected Premises System?
"When it operates, the temperature of the surrounding air Fixed Temperature
will always be higher than the rated temperature of the
device itself"; describes which device below
A single element spot-type detector which may; inhibit Rate of Rise
contact closure until the total device has been heated to
its rated temperature or; close its contacts on a fast rate-
of-temperature rise even if the device has not yet
reached the rated temperature
Spot type Heat Sensing Fire Detectors mounted on the Not less than 4 inches form the sidewall
ceiling shall be
For Fire Alarm systems "Cu" is the standard abbreviation Copper as in copper wire
used for
True or False: The purpose of NFPA 70 is the practical False
safeguarding of persons and property from hazards
arising from the use of electricity and does NOT regulate
the neatness of an installation
A device that senses visible or invisible particles of Smoke Detector
combustion
Select the detector and operating principle most Ionization Smoke Detector
appropriate to detect thin gaseous products of
combustion and nearly invisible particulate matter .01
micron to .3 micron in size
