NJ Black Seal Test| Answered 100% correctly|

NJ Black Seal Test| Answered 100% correctly| The ASME Code states that the setting on the high limit pressure control on a low pressure steam boiler shall not exceed: 15 psig By definition, a boiler is an open vessel in which water is turned to steam under pressure by the application of heat. True or False? False By N.J.A.C. rules, a school with a boiler plant with a total interconnected capacity of 100 BHP would require a properly licensed operator to be present whenever the building was deemed occupied. True or False? False According to state boiler regulations, where should the boiler registration number be located? on the front of the boiler A boiler operator's log shall be maintained in each plant containing over: 100 Boiler Hp If in good standing, an expired license can be renewed within a period of: 3 years The low pressure black seal license will permit you to operate boiler plants of up to: no limit What is the maximum penalty for performing the duties of a boiler operator with an expired license? $5,000.00 Where on the Certificate of Inspection would you find the State of New Jersey jurisdiction number? upper left corner What is the maximum temperature and pressure a hot water supply boiler can have to be considered a low pressure boiler? 160 psi at 250 degrees F The observed pressure of a heating system when it is in an idle or non-operating mode is called: This is known as the static pressure of the system The primary purpose of establishing a set of plant safety rules is to: protect the workers and equipment What are the four systems required to operate a steam boiler? steam, feedwater, fuel and draft Low pressure boilers shall comply with what section of the ASME code? IV What is the official ASME letter stamp used to denote low pressure heating boilers? H Which of the following statements regarding a hydronic heating system is accurate in its description? 1. the water circulation must take the water from the boiler and move it through the individual terminals or heating units where the heat is emitted and then return the water to the condensate tank. 2. the water circulator takes the water from the feed pump discharge and moves it through the individual terminals or heating units where the heat is absorbed and any remaining steam turns to liquid then it is returned to the boiler to be reused again. 3. the water circulator must take the water from the boiler and move it through the individual terminals or heating units where the heat is emitted and then returns the water to the boiler to be