Electrical Safety Test Review_ Level 2 –Electrical
exam revision
Safetysummary.pdf
Test Review_ Level 2 –Electrical
exam revision
Safetysummary.pdf
Test Review_ Level 2 – exam revision summary.pdf
Electrical Safety
Test Review: Level
2 – exam revision
summary
Electrical Safety Test Review_ Level 2 –Electrical
exam revision
Safetysummary.pdf
Test Review_ Level 2 –Electrical
exam revision
Safetysummary.pdf
Test Review_ Level 2 – exam revision summary.pdf
,Electrical Safety Test Review_ Level 2.pdf Electrical Safety Test Review_ Level 2.pdf Electrical Safety Test Review_ Level 2.pdf
Low voltage 48 VDC current under fault conditions in Thermal Burn
electrical equipment could pose which of the following
electrical hazards?
A 600-volt, current-limiting fuse with a 200-kiloamp Both - Likelihood and severity
interrupting rating when arcing currents are in the current
limiting region can impact which of the following
components of risk?
Adding line-side barriers to the service overcurrent Likelihood
protective device impacts which of the following
components of risk?
The further away from the arcing source, the ? the Lower
incident energy is.
Tingling sensation can be expected on a 60-hertz AC 0.5 to 3 mA
circuit when the current passing through the body in
milli-amperes is ? .
The threshold in cal/cm for an incurable burn is ? . 1.2 cal/cm2
Which of the following is a cause of an electrical shock Insulation failure or damaged wiring
hazard?
Electrical Safety Test Review_ Level 2.pdf Electrical Safety Test Review_ Level 2.pdf Electrical Safety Test Review_ Level 2.pdf
, Electrical Safety Test Review_ Level 2.pdf Electrical Safety Test Review_ Level 2.pdf Electrical Safety Test Review_ Level 2.pdf
The arcing current is ? the bolted fault current value. less than
A circuit breaker that is equipped with an energy Severity
reduction maintenance switch can impact which of the
following components of risk?
Placing a circuit breaker equipped with an energy Severity
reduction maintenance switch next to the equipment it
supplies power to will impact which of the following
components of risk?
Per 29 CFR Part 1926, insulating equipment shall be Air
inspected for damage before each day's use and
immediately following any incident that can reasonably
be suspected of causing damage. Insulating gloves shall
be given a(n) ? test, along with the inspection.
Per Subpart C of 29 CFR Part 1926, the employer shall Recognition and avoidance of unsafe conditions and the regulations applicable
instruct each employee in the ? their work environment to
to control or eliminate any hazards or other exposure to
illness or injury.
Electrical Safety Test Review_ Level 2.pdf Electrical Safety Test Review_ Level 2.pdf Electrical Safety Test Review_ Level 2.pdf
exam revision
Safetysummary.pdf
Test Review_ Level 2 –Electrical
exam revision
Safetysummary.pdf
Test Review_ Level 2 – exam revision summary.pdf
Electrical Safety
Test Review: Level
2 – exam revision
summary
Electrical Safety Test Review_ Level 2 –Electrical
exam revision
Safetysummary.pdf
Test Review_ Level 2 –Electrical
exam revision
Safetysummary.pdf
Test Review_ Level 2 – exam revision summary.pdf
,Electrical Safety Test Review_ Level 2.pdf Electrical Safety Test Review_ Level 2.pdf Electrical Safety Test Review_ Level 2.pdf
Low voltage 48 VDC current under fault conditions in Thermal Burn
electrical equipment could pose which of the following
electrical hazards?
A 600-volt, current-limiting fuse with a 200-kiloamp Both - Likelihood and severity
interrupting rating when arcing currents are in the current
limiting region can impact which of the following
components of risk?
Adding line-side barriers to the service overcurrent Likelihood
protective device impacts which of the following
components of risk?
The further away from the arcing source, the ? the Lower
incident energy is.
Tingling sensation can be expected on a 60-hertz AC 0.5 to 3 mA
circuit when the current passing through the body in
milli-amperes is ? .
The threshold in cal/cm for an incurable burn is ? . 1.2 cal/cm2
Which of the following is a cause of an electrical shock Insulation failure or damaged wiring
hazard?
Electrical Safety Test Review_ Level 2.pdf Electrical Safety Test Review_ Level 2.pdf Electrical Safety Test Review_ Level 2.pdf
, Electrical Safety Test Review_ Level 2.pdf Electrical Safety Test Review_ Level 2.pdf Electrical Safety Test Review_ Level 2.pdf
The arcing current is ? the bolted fault current value. less than
A circuit breaker that is equipped with an energy Severity
reduction maintenance switch can impact which of the
following components of risk?
Placing a circuit breaker equipped with an energy Severity
reduction maintenance switch next to the equipment it
supplies power to will impact which of the following
components of risk?
Per 29 CFR Part 1926, insulating equipment shall be Air
inspected for damage before each day's use and
immediately following any incident that can reasonably
be suspected of causing damage. Insulating gloves shall
be given a(n) ? test, along with the inspection.
Per Subpart C of 29 CFR Part 1926, the employer shall Recognition and avoidance of unsafe conditions and the regulations applicable
instruct each employee in the ? their work environment to
to control or eliminate any hazards or other exposure to
illness or injury.
Electrical Safety Test Review_ Level 2.pdf Electrical Safety Test Review_ Level 2.pdf Electrical Safety Test Review_ Level 2.pdf
