175 psi (1207 kPa) is applied to a clutch piston with a radius
of 3" (6" diameter). What is the total clamping force?
4,000 lb
4,500 lb
4,700 lb
4,900 lb
4,900 lb
,After the transmission is installed properly into the vehicle,
approximately what percentage of the total transmission
fluid should be added to the transmission?
100%
50%
75%
25%
75%
,All of the following are advantages of using the clutch and
band application charts EXCEPT:
Easy diagnosis of the fault.
Arriving at a better estimate of the cost.
Determining that it may not be necessary to remove the
transmission from the vehicle for repair.
Determining that the transmission does not need repair.
Determining that the transmission does not need repair.
, All of the following statements are true EXCEPT:
The PCM or the TCM is the brain in the system.
The PCM monitors the TPS sensor along with the VSS to
determine a driver's driving pattern.
Slippery conditions require a gear ratio that enhances the
traction of the vehicle.
Increasing the amount of torque being transmitted to the
transmission reduces transmission wear.
Increasing the amount of torque being transmitted to the
transmission reduces transmission wear.
of 3" (6" diameter). What is the total clamping force?
4,000 lb
4,500 lb
4,700 lb
4,900 lb
4,900 lb
,After the transmission is installed properly into the vehicle,
approximately what percentage of the total transmission
fluid should be added to the transmission?
100%
50%
75%
25%
75%
,All of the following are advantages of using the clutch and
band application charts EXCEPT:
Easy diagnosis of the fault.
Arriving at a better estimate of the cost.
Determining that it may not be necessary to remove the
transmission from the vehicle for repair.
Determining that the transmission does not need repair.
Determining that the transmission does not need repair.
, All of the following statements are true EXCEPT:
The PCM or the TCM is the brain in the system.
The PCM monitors the TPS sensor along with the VSS to
determine a driver's driving pattern.
Slippery conditions require a gear ratio that enhances the
traction of the vehicle.
Increasing the amount of torque being transmitted to the
transmission reduces transmission wear.
Increasing the amount of torque being transmitted to the
transmission reduces transmission wear.
