CHST PREP TEST BANK EXAM COMPREHENSIVE EXAM WITH
COMPLETE QUESTIONS AND ACCURATE DETAILED ANSWERS
NEWEST VERSION|| (VERIFIED ANSWERS) ASSURED PASS
ALREADY GRADED A+
Which of the following is NOT considered a significant factor in
determining the outcome of an electrocution event?
1. The amount of electrically resistant material present in work
boots and work gloves.
A Noise-Hazard Control Program (and associated Hearing
Conservation Program) is required under OSHA regulation 29
CFR 1910.95
(Occupational Noise Exposure) where workers may be exposed
to noise levels in excess of an eight -hour-time-weighted
average of..
2. 85 decibels (dB)
As per 29 CFR 1910.1001, the allowable eight-hour exposure limit
concentration to asbestos fibers is not to exceed which of the
following?
3. 0.1 fibers per cm^3 of air
,Per OSHA regulations 29 CFR 1910.25-1910.27, the maximum
length a single ladder or a single section of ladder may be is..
4. No greater than 30 feet
Which of the following is NOT stipulated as a hazardous waste
material attribute to which the U.S. Environmental Protection
Agency extends a designated waste code (e.g., #D001), as per
40 CFR 261, Subpart C?
5. Mutagenicity
In a construction environment, which of the following types of
PPE is most suitable for protecting the eyes against airborne
dust?
6. Safety goggles
At what minimum frequency must electrical-insulating gloves be
tested to ensure they adequately protect workers against
electrical shock?
7. Every six months
The most useful tool that CHST's can potentially use for
evaluating system safety levels at smaller-scale worksites is
a(n):
8. Job Safety Analysis (JSA)
,If 25 or more employees are to be working unserground at the
same time, which of the following safety procedures MUST be
in effect?
9. Two separate rescue teams must be available. One within 30
minutes travel and the second within two hours travel
If a five-foot deep trench is dug in clay material, what angle must
the trench wall not exceed?
10. 53 degrees
"Lifting Index" (LI) is calculated per which of the following?
11. Load weight / recommended weight limit
"Flash Point" is most accurately defined as which of the following?
12. The lowest temperature at which a flammable liquid can form
an ignitable mixture in air
, Which of the following does a mobile crane operator NOT need
to be aware of in order to ensure a safe lift?
13. The width of the jib
To what part of the body does a body harness typically NOT
distribute any significant fall-arrest force?
14. Lower back
" Recommended weight limit" (RWL) is most accurately defined
as which of the following?
15. The weight that healthy workers could lift for up to eight
hours without causing injuries
The Heinrich "incident to injury ratio" model states that for
every 330 accidents,---- result in no injuries, ---- cause minor
injuries, and ----cause major injuries.
16. 300,29,1
COMPLETE QUESTIONS AND ACCURATE DETAILED ANSWERS
NEWEST VERSION|| (VERIFIED ANSWERS) ASSURED PASS
ALREADY GRADED A+
Which of the following is NOT considered a significant factor in
determining the outcome of an electrocution event?
1. The amount of electrically resistant material present in work
boots and work gloves.
A Noise-Hazard Control Program (and associated Hearing
Conservation Program) is required under OSHA regulation 29
CFR 1910.95
(Occupational Noise Exposure) where workers may be exposed
to noise levels in excess of an eight -hour-time-weighted
average of..
2. 85 decibels (dB)
As per 29 CFR 1910.1001, the allowable eight-hour exposure limit
concentration to asbestos fibers is not to exceed which of the
following?
3. 0.1 fibers per cm^3 of air
,Per OSHA regulations 29 CFR 1910.25-1910.27, the maximum
length a single ladder or a single section of ladder may be is..
4. No greater than 30 feet
Which of the following is NOT stipulated as a hazardous waste
material attribute to which the U.S. Environmental Protection
Agency extends a designated waste code (e.g., #D001), as per
40 CFR 261, Subpart C?
5. Mutagenicity
In a construction environment, which of the following types of
PPE is most suitable for protecting the eyes against airborne
dust?
6. Safety goggles
At what minimum frequency must electrical-insulating gloves be
tested to ensure they adequately protect workers against
electrical shock?
7. Every six months
The most useful tool that CHST's can potentially use for
evaluating system safety levels at smaller-scale worksites is
a(n):
8. Job Safety Analysis (JSA)
,If 25 or more employees are to be working unserground at the
same time, which of the following safety procedures MUST be
in effect?
9. Two separate rescue teams must be available. One within 30
minutes travel and the second within two hours travel
If a five-foot deep trench is dug in clay material, what angle must
the trench wall not exceed?
10. 53 degrees
"Lifting Index" (LI) is calculated per which of the following?
11. Load weight / recommended weight limit
"Flash Point" is most accurately defined as which of the following?
12. The lowest temperature at which a flammable liquid can form
an ignitable mixture in air
, Which of the following does a mobile crane operator NOT need
to be aware of in order to ensure a safe lift?
13. The width of the jib
To what part of the body does a body harness typically NOT
distribute any significant fall-arrest force?
14. Lower back
" Recommended weight limit" (RWL) is most accurately defined
as which of the following?
15. The weight that healthy workers could lift for up to eight
hours without causing injuries
The Heinrich "incident to injury ratio" model states that for
every 330 accidents,---- result in no injuries, ---- cause minor
injuries, and ----cause major injuries.
16. 300,29,1
