NICET Fire Alarm Level I Actual Exam Questions And
Verified Solutions | Latest Update 2026/2027 | 100%
Correct Answers | Verified | Graded A+.
An existing fire alarm cable in a drop ceiling will be spliced. which one of
the following splice locations will comply with NFPA
70?=ANSWER=secured inside a listed box or enclosure
Any current in excess of the rated current of equipment of the ampacity of a
conductor. It may result from overload, short circuit, or ground
fault.=ANSWER=Overcurrent
At minimum, when working near power lines with voltage of 600 volts and
lower, an aerial lift operator shall maintain which distance from the
lines?=ANSWER=10 feet
,A device suitable for connection to a circuit that has a sensor that responds
to a physical stimulus such as gas, heat, or smoke.=ANSWER=Detector
A load where the maximum current is expected to continue for 3 hours or
more.=ANSWER=Continuous Load
A meter will be used to measure a horn strobe circuit current draw. Which
of the following statements is correct?=ANSWER=The meter should be
connected in series with the circuit; it must be located before the first
device(horn or strobe). ?
A riser room temperature switch should activate when the temperature falls
below which level?=ANSWER=40 degrees F
Class 1 circuit=ANSWER=The portion of the wiring system between the
load side of the overcurrent device.
A circuit class is not monitored for integrity?=ANSWER=Class E
, A Crew member has a suspected leg fracture. Before moving the crew
member, what is the recommended first step I'm treating the
injury?=ANSWER=Immobilize the leg
At which height must cables be physically protected when being installed
within an exposed ceiling?=ANSWER=7
feet
Ceilings that have solid structural or solid nonstructural members projecting
down from the ceiling surface more than 4 in. and spaced more than 36 in
apart, center to center.=ANSWER=Beam Construction
A device intended to provide protection from the effects of arc faults by the
recognizing characteristics unique to arcing and by functioning to
deenergize the circuit what an arc fault is detected=ANSWER=Arc-Fault
Circuit
Interrupter(AFCI)
Verified Solutions | Latest Update 2026/2027 | 100%
Correct Answers | Verified | Graded A+.
An existing fire alarm cable in a drop ceiling will be spliced. which one of
the following splice locations will comply with NFPA
70?=ANSWER=secured inside a listed box or enclosure
Any current in excess of the rated current of equipment of the ampacity of a
conductor. It may result from overload, short circuit, or ground
fault.=ANSWER=Overcurrent
At minimum, when working near power lines with voltage of 600 volts and
lower, an aerial lift operator shall maintain which distance from the
lines?=ANSWER=10 feet
,A device suitable for connection to a circuit that has a sensor that responds
to a physical stimulus such as gas, heat, or smoke.=ANSWER=Detector
A load where the maximum current is expected to continue for 3 hours or
more.=ANSWER=Continuous Load
A meter will be used to measure a horn strobe circuit current draw. Which
of the following statements is correct?=ANSWER=The meter should be
connected in series with the circuit; it must be located before the first
device(horn or strobe). ?
A riser room temperature switch should activate when the temperature falls
below which level?=ANSWER=40 degrees F
Class 1 circuit=ANSWER=The portion of the wiring system between the
load side of the overcurrent device.
A circuit class is not monitored for integrity?=ANSWER=Class E
, A Crew member has a suspected leg fracture. Before moving the crew
member, what is the recommended first step I'm treating the
injury?=ANSWER=Immobilize the leg
At which height must cables be physically protected when being installed
within an exposed ceiling?=ANSWER=7
feet
Ceilings that have solid structural or solid nonstructural members projecting
down from the ceiling surface more than 4 in. and spaced more than 36 in
apart, center to center.=ANSWER=Beam Construction
A device intended to provide protection from the effects of arc faults by the
recognizing characteristics unique to arcing and by functioning to
deenergize the circuit what an arc fault is detected=ANSWER=Arc-Fault
Circuit
Interrupter(AFCI)
