NYC Electrician Civil Service
Mock Exam
2026_2027
Expert-Verified Questions and
Answers
(With A+ Grades Guarantee)
,What is the maximum continuous 16 Amperes
load permitted on a 20-ampere
overcurrent protection device?
Which of the following is strictly Underground gas piping systems
prohibited for use as a grounding
electrode?
What is the maximum number of No. 9 Conductors
12 AWG THHN conductors permitted
in a 1/2-inch EMT conduit?
How many degrees of total bends are 360 degrees
permitted between pull points in a
single run of conduit?
What is the multiplier used to 8 times the trade size
calculate the minimum length of a pull
box for a straight pull of conduits?
What is the maximum distance 3 feet
allowed between a box and the first
structural support for EMT conduit?
Which color is reserved exclusively White
for the grounded circuit conductor
(neutral)?
What instrument is used to measure Megohmmeter
high-value electrical insulation
resistance?
What is the demand factor applied to 100%
the first 3,000 volt-amperes of a
general lighting load in a dwelling?
What is the minimum depth required 8 feet
for a standard ground rod driven into
the earth?
, What type of overcurrent condition is Short circuit
caused by a direct connection
between a hot phase and a neutral
wire?
What size equipment grounding 14 AWG
conductor is required for a branch
circuit protected by a 15-ampere
device?
What is the synchronous speed of a 1800 RPM
4-pole AC motor operating at a
frequency of 60 Hz?
How are ammeters connected relative In series
to the load being measured?
What is the minimum clear working 3 feet
space depth required in front of live
electrical equipment operating at
120V to ground?
What device automatically opens a Ground-Fault Circuit-Interrupter
circuit when a current imbalance
between hot and neutral wires
exceeds 5 milliamperes?
What type of enclosure is specifically NEMA 1
designed for indoor use to protect
workers against dust and falling dirt?
What is the total resistance of two 10- 5 Ohms
ohm resistors connected in a parallel
configuration?
Which formula correctly expresses I=V/R
Ohm's Law for calculating current?
Mock Exam
2026_2027
Expert-Verified Questions and
Answers
(With A+ Grades Guarantee)
,What is the maximum continuous 16 Amperes
load permitted on a 20-ampere
overcurrent protection device?
Which of the following is strictly Underground gas piping systems
prohibited for use as a grounding
electrode?
What is the maximum number of No. 9 Conductors
12 AWG THHN conductors permitted
in a 1/2-inch EMT conduit?
How many degrees of total bends are 360 degrees
permitted between pull points in a
single run of conduit?
What is the multiplier used to 8 times the trade size
calculate the minimum length of a pull
box for a straight pull of conduits?
What is the maximum distance 3 feet
allowed between a box and the first
structural support for EMT conduit?
Which color is reserved exclusively White
for the grounded circuit conductor
(neutral)?
What instrument is used to measure Megohmmeter
high-value electrical insulation
resistance?
What is the demand factor applied to 100%
the first 3,000 volt-amperes of a
general lighting load in a dwelling?
What is the minimum depth required 8 feet
for a standard ground rod driven into
the earth?
, What type of overcurrent condition is Short circuit
caused by a direct connection
between a hot phase and a neutral
wire?
What size equipment grounding 14 AWG
conductor is required for a branch
circuit protected by a 15-ampere
device?
What is the synchronous speed of a 1800 RPM
4-pole AC motor operating at a
frequency of 60 Hz?
How are ammeters connected relative In series
to the load being measured?
What is the minimum clear working 3 feet
space depth required in front of live
electrical equipment operating at
120V to ground?
What device automatically opens a Ground-Fault Circuit-Interrupter
circuit when a current imbalance
between hot and neutral wires
exceeds 5 milliamperes?
What type of enclosure is specifically NEMA 1
designed for indoor use to protect
workers against dust and falling dirt?
What is the total resistance of two 10- 5 Ohms
ohm resistors connected in a parallel
configuration?
Which formula correctly expresses I=V/R
Ohm's Law for calculating current?
