What kind of line is shown in the drawing below?
Give this one a try later!
Center Line
In Europe, drawings use first angle projection. This method is preferred by which
standards organization?
Give this one a try later!
ISO
,Object lines are always drawn as a thick solid line.
Give this one a try later!
True
The quality plan documents how the company is going to reach its quality goals in
the scope of the __________.
Give this one a try later!
Quality management system
A __________ is an important measuring tool in manufacturing because it can easily
be carried in a pocket and provides quick measurements and approximate
dimensions.
Give this one a try later!
Machinist's rule
What will be the final width of a part designed at a width 2.0625 inches and reduced
by 3/8 of an inch?
Give this one a try later!
, 1.6875 inches
Which drawing method is a form of free-hand drawing?
Give this one a try later!
Sketching
First piece inspection is required for __________.
Give this one a try later!
Documenting repeatable setups
To reduce variation, minimize defects, and to shorten cycle time are considered
__________ goals.
Give this one a try later!
Quality
Two systems of dimensional measurement used in manufacturing are the SI Metric
System and the __________.
Give this one a try later!
Give this one a try later!
Center Line
In Europe, drawings use first angle projection. This method is preferred by which
standards organization?
Give this one a try later!
ISO
,Object lines are always drawn as a thick solid line.
Give this one a try later!
True
The quality plan documents how the company is going to reach its quality goals in
the scope of the __________.
Give this one a try later!
Quality management system
A __________ is an important measuring tool in manufacturing because it can easily
be carried in a pocket and provides quick measurements and approximate
dimensions.
Give this one a try later!
Machinist's rule
What will be the final width of a part designed at a width 2.0625 inches and reduced
by 3/8 of an inch?
Give this one a try later!
, 1.6875 inches
Which drawing method is a form of free-hand drawing?
Give this one a try later!
Sketching
First piece inspection is required for __________.
Give this one a try later!
Documenting repeatable setups
To reduce variation, minimize defects, and to shorten cycle time are considered
__________ goals.
Give this one a try later!
Quality
Two systems of dimensional measurement used in manufacturing are the SI Metric
System and the __________.
Give this one a try later!
