DeVry University, ChicagoNETW 420NETW420_Bi-Weekly_Project_Week 7.docx

Running head: BI-WEEKLY PROJECT FOR WEEK 7 1 Bi-Weekly Project for Week 7 Team 4 DeVry University Author Note This project paper was prepared for NETW-420 taught by Professor: Bi-Weekly Project Week #: __7__ Q1. This study source was downloaded by from CourseH on :14:44 GMT -06:00 BI-WEEKLY PROJECT FOR WEEK 7 2 Fill in the R2 routing table (a) for paths with no tunnels and (b) for paths with tunnels T1 and T2. The address of each router is x.x.x.x where x is the router number, e.g., 1.1.1.1. The network shown in Figure 12.44 is an MPLS network with all routers configured as LabelSwitching Routers (LSRs). The paths (LSPs) are determined using TE (Traffic Engineering). Tunnels T1 and T2 derive from the LSR’s R2 and R5 and conclude at R4. R3 uses Tunnel 1 and R6 uses Tunnel 2 and they act as a pass through. (a) Routing table for paths with no tunnels (R2): Destination Output Interface Next hop Metric 1.1.1.1 I1 1.1.1.1 1 3.3.3.3 I3 3.3.3.3 1 4.4.4.4 I3 3.3.3.3 2 5.5.5.5 I5 5.5.5.5 1 6.6.6.6 I5 5.5.5.5 2 I3 3.3.3.3 3 (b) Routing table for paths with tunnels T1 and T2 (R2): Destination Output Interface