IFT 266 Introduction to Network Information Communication Technology (ICT) Lab 6 Switch Configuration (Speed & Duplex)

IFT 266 Introduction to Network Information Communication Technology (ICT) Lab 6 Switch Configuration (Speed & Duplex) IFT 266 Introduction to Network Information Communication Technology (ICT) Lab 6 Switch Configuration (Speed & Duplex) After you complete each step, put an ‘x’ in the completed box 1. In Packet Tracer setup the following topology. You can use two generic switches, but you will need to add in some Gigabit ports to the switch. Use a crossover cable as the transmission media. When adding the Gigabit ports, there are two modules that you can choose from based on copper or optical connectivity (s). • PT-SWITCH-NM-1CGE - Single-port Cisco Gigabit Ethernet Network Module (part number PT-SWITCH-NM-1CGE) provides Gigabit Ethernet copper connectivity • PT-SWITCH-NM-1FGE - Single-port Cisco Gigabit Ethernet Network Module (part number PTSWITCH-NM-1FGE) provides Gigabit Ethernet optical connectivity