Drone certification reference questions and answers 2023
solved correctly
(Refer to FAA-CT-8080-2H, Figure 25, Area 3.) The floor of Class B airspace at Dallas
Executive (RBD) is
3,000 feet MSL
(Refer to Figure 25, area 4.) What is the floor of Class B airspace at Ft. Worth Alliance
(AFW) airport?
4,000 feet MSL
(Refer to Figure 23, area 3.) What is the floor of the Savannah Class C airspace at the
shelf area (outer circle)?
1,300 feet MSL
(Refer to Figure 69) What does the [25] indicate in the airspace surrounding Naval Air
Station Kingsville (NQI)?
Class D airspace with 2,500 feel ceiling
(Refer to Figure 25, Area 2) The airspace directly overlying Addison airport (ADS) is
Class D below 3,000 feet
(Refer to Figure 75.) You've been asked to fly your UA to inspect a bridge being built in
the southernmost part of Gila Bend.
You need permission from the FAA to operate here
(Refer to Figure 69, area 7.) When an aircraft lands at Alice Intl (ALI), what airspace
class is it in?
Class G
(Refer to Figure 26, area 5.) The airspace overlying and surrounding a 5 mile radius
from Barnes County Airport (BAC) is
Class G airspace from the surface to 700 feet AGL
(Refer to Figure 26) What airspace is Tomlinson airport in?
Class G airspace -- surface up to but not including 1,200 feet AGL; Class E airspace --
1,200 feet AGL up to but not including 18,000 feet MSL.
(Refer to Figure 78) Identify the airspace over Onawa airport (K36).
Class G airspace - surface up to but not including 1,200 feet AGL, Class E airspace -
1,200 feet AGL up to but not including 18,000 feet MSL.
(Refer to Figure 75, area 2.) You're planning to fly your sUAS about 50 feet away from
Pierce airport at an altitude of 80 feet AGL. What do you need to do?
Nothing, no notification / permission is required.
(Refer to FAA-CT-8080-2H, Figure 75) Where should you look to get additional
information on R-2305?
On the Sectional Chart
(Refer to Figure 21) You have been hired by a farmer to use your small UA to inspect
his crops. The area that you are to survey is in the Devil's Lake West MOA, east of area
2. How would you find out if the MOA is active?
Refer to the Sectional Chart legend on the border of the chart.
(Refer to Figure 21) You have been hired by a farmer to use your small unmanned
aircraft to inspect his crops. The area that you are to survey is in the Devil's Lake West
MOA, east of area 2. How would you find out if the MOA is active?
, Contact Flight Service
(Refer to Figure 74) Where should you look to find out whether or not you're allowed to
operate in R-2531?
Sectional Chart
(Refer to Figure 23.) What does a restricted area like R-3005C mean?
Unusual, often invisible, hazards to aircraft like artillery firing, aerial gunnery, or guided
missiles.
(Refer to FAA-CT-8080-2H, Figure 59, Area 2) The four lines that are labeled beginning
with VR indicate
Military training routes.
(Refer to FAA-CT-8080-2H, Figure 59, area 2.) The chart shows a gray line with
"VR1667, VR1617, VR1638, and VR1668." Could this area present a hazard to the
operations of a small UA?
Yes, this is a Military Training Route with at least one route 1,500 feet AGL and below.
(Refer to Figure 21) What type military flight operations should a pilot expect along
IR644 in the Devil's Lake West MOA?
IFR training flights above 1,500 feet AGL at speeds in excess of 250 knots.
(Refer to Figure 20, area 3.) How would a remote PIC "CHECK NOTAMS" as noted in
the CAUTION box regarding the unmarked balloon?
By obtaining a briefing via an online source such as: 1800WXBrief.com.
(Refer to Figure 20, area 5.) Who would a Remote Pilot in Command contact to
"CHECK NOTAMS" as it is noted in the CAUTION box regarding the unmarked
balloon?
flight service
(Refer to FAA-CT-8080-2H, Figure 21.) What airport is located approximately 47
(degrees) 40 (minutes) N latitude and 101 (degrees) 26 (minutes) W longitude?
Garrison Airport
(Refer to FAA-CT-8080-2H, Figure 26.) What does the line of latitude at area 4
measure?
The degrees of latitude north and south from the equator
(Refer to FAA-CT-8080-2H, Figure 20, area 3.) Determine the approximate latitude and
longitude of Currituck County Airport.
36°24'N - 76°01'W
(Refer to FAA-CT-8080-2H, Figure 21, area 2.) Which airport is located at
approximately 47°34'30"N latitude and 100°44'00"W longitude?
Makeeff
(Refer to FAA-CT-8080-2H, Figure 21, area 3.) Which airport is located at
approximately 47°21'N latitude and 101°01'W longitude?
Washburn
(Refer to FAA-CT-8080-2H, Figure 22, area 3.) Determine the approximate latitude and
longitude of Shoshone County Airport.
47°33'N - 116°11'W
(Refer to FAA-CT-8080-2H, Figure 26, area 2.) What is the approximate latitude and
longitude of Cooperstown Airport?
47°25'N - 98°06'W
solved correctly
(Refer to FAA-CT-8080-2H, Figure 25, Area 3.) The floor of Class B airspace at Dallas
Executive (RBD) is
3,000 feet MSL
(Refer to Figure 25, area 4.) What is the floor of Class B airspace at Ft. Worth Alliance
(AFW) airport?
4,000 feet MSL
(Refer to Figure 23, area 3.) What is the floor of the Savannah Class C airspace at the
shelf area (outer circle)?
1,300 feet MSL
(Refer to Figure 69) What does the [25] indicate in the airspace surrounding Naval Air
Station Kingsville (NQI)?
Class D airspace with 2,500 feel ceiling
(Refer to Figure 25, Area 2) The airspace directly overlying Addison airport (ADS) is
Class D below 3,000 feet
(Refer to Figure 75.) You've been asked to fly your UA to inspect a bridge being built in
the southernmost part of Gila Bend.
You need permission from the FAA to operate here
(Refer to Figure 69, area 7.) When an aircraft lands at Alice Intl (ALI), what airspace
class is it in?
Class G
(Refer to Figure 26, area 5.) The airspace overlying and surrounding a 5 mile radius
from Barnes County Airport (BAC) is
Class G airspace from the surface to 700 feet AGL
(Refer to Figure 26) What airspace is Tomlinson airport in?
Class G airspace -- surface up to but not including 1,200 feet AGL; Class E airspace --
1,200 feet AGL up to but not including 18,000 feet MSL.
(Refer to Figure 78) Identify the airspace over Onawa airport (K36).
Class G airspace - surface up to but not including 1,200 feet AGL, Class E airspace -
1,200 feet AGL up to but not including 18,000 feet MSL.
(Refer to Figure 75, area 2.) You're planning to fly your sUAS about 50 feet away from
Pierce airport at an altitude of 80 feet AGL. What do you need to do?
Nothing, no notification / permission is required.
(Refer to FAA-CT-8080-2H, Figure 75) Where should you look to get additional
information on R-2305?
On the Sectional Chart
(Refer to Figure 21) You have been hired by a farmer to use your small UA to inspect
his crops. The area that you are to survey is in the Devil's Lake West MOA, east of area
2. How would you find out if the MOA is active?
Refer to the Sectional Chart legend on the border of the chart.
(Refer to Figure 21) You have been hired by a farmer to use your small unmanned
aircraft to inspect his crops. The area that you are to survey is in the Devil's Lake West
MOA, east of area 2. How would you find out if the MOA is active?
, Contact Flight Service
(Refer to Figure 74) Where should you look to find out whether or not you're allowed to
operate in R-2531?
Sectional Chart
(Refer to Figure 23.) What does a restricted area like R-3005C mean?
Unusual, often invisible, hazards to aircraft like artillery firing, aerial gunnery, or guided
missiles.
(Refer to FAA-CT-8080-2H, Figure 59, Area 2) The four lines that are labeled beginning
with VR indicate
Military training routes.
(Refer to FAA-CT-8080-2H, Figure 59, area 2.) The chart shows a gray line with
"VR1667, VR1617, VR1638, and VR1668." Could this area present a hazard to the
operations of a small UA?
Yes, this is a Military Training Route with at least one route 1,500 feet AGL and below.
(Refer to Figure 21) What type military flight operations should a pilot expect along
IR644 in the Devil's Lake West MOA?
IFR training flights above 1,500 feet AGL at speeds in excess of 250 knots.
(Refer to Figure 20, area 3.) How would a remote PIC "CHECK NOTAMS" as noted in
the CAUTION box regarding the unmarked balloon?
By obtaining a briefing via an online source such as: 1800WXBrief.com.
(Refer to Figure 20, area 5.) Who would a Remote Pilot in Command contact to
"CHECK NOTAMS" as it is noted in the CAUTION box regarding the unmarked
balloon?
flight service
(Refer to FAA-CT-8080-2H, Figure 21.) What airport is located approximately 47
(degrees) 40 (minutes) N latitude and 101 (degrees) 26 (minutes) W longitude?
Garrison Airport
(Refer to FAA-CT-8080-2H, Figure 26.) What does the line of latitude at area 4
measure?
The degrees of latitude north and south from the equator
(Refer to FAA-CT-8080-2H, Figure 20, area 3.) Determine the approximate latitude and
longitude of Currituck County Airport.
36°24'N - 76°01'W
(Refer to FAA-CT-8080-2H, Figure 21, area 2.) Which airport is located at
approximately 47°34'30"N latitude and 100°44'00"W longitude?
Makeeff
(Refer to FAA-CT-8080-2H, Figure 21, area 3.) Which airport is located at
approximately 47°21'N latitude and 101°01'W longitude?
Washburn
(Refer to FAA-CT-8080-2H, Figure 22, area 3.) Determine the approximate latitude and
longitude of Shoshone County Airport.
47°33'N - 116°11'W
(Refer to FAA-CT-8080-2H, Figure 26, area 2.) What is the approximate latitude and
longitude of Cooperstown Airport?
47°25'N - 98°06'W
