ICC Study guide 2023 with verified questions and answers

In which tab can you activate an ABT asset? Tab 5 What does PDB stand for? Post Deployment Build What does EAC stand for? Echelon Above Corps Which tab is used for general purpose maps entries? Tab 72 True or False; Launcher dead zones only apply to ABT engagements and not TBM engagements. True What would the engagement status on track amp data tab be if a TBM is engageable but the predicted GIP is not threatening the FU or an active asset? IPOUT Which tab is used to assign an ICC identification number, determine addresses used by the ICC for data communication, and to designate the ICC to be used as a direct link relay? ( Mykids) Tab 67 Which tab is used to enter the BNSCC? Tab 58 Tab ___ allows and prohibits the ICC to make changes in the communications control and track reporting parameters for FUs? Tab 2 Tab ___ controls battalion communications; Tab ___ controls FP communications; Tab ___ controls extra battalion communications. Tabs 67, 68, 69 The ICC can control ___ PATRIOT fire units at one time. 6 True or False; TBM launch points will be automatically sent to the ICC, but only if authorized in Tab 14. False What does MICC stand for? Master Information Coordination Central True or False; On the CRT, operator-generated alerts appear on the left side of the screen. False What does DLRP stand for? Data Link Reference Point Which tab permits the operator to enter the upper and lower limits of the four altitude band filters? Tab 14 Which tab enables the ICC operator to range targets using the cursor? Tab 4 Tab ___ is deployment/command planning. 51 True or False; The ICC can plan and enter locations for PATRIOT, Hawk and THAAD FPs. True Which tab is used to enter threat center location, radius, and threat type? Tab 56 TADIL addresses for the ICC are found in which USMTF message? OPTASK-LINK What piece of equipment does the following best describes: encrypts all UHF data to be transmitted and decrypts received data? KG 194 The PAC-3 missile is divided into how many different sections? 5 The database is updated in tab ___? 13 True or False; The dead space for PATRIOT is 3 KM in front of the radar. True Which tab allows the operator to enter data to define reduced search sectors for selection by DROP LONG RANGE, DROP SHORT RANGE switches on control indicator? Tab 55 Which tab allows the operator to see all of the assets and volumes that have been initialized in the database, and to see which of them have been activated at each FP? Tab 5 Which IFF mode is present prior to flight for personal identity, tail number, or unit, origin, used mainly for flight plan correlation at higher echelon and is not interrogated by PATRIOT? Mode 2 True or False; The site amp data tab combines information found in battalion status, FP status, battalion missile inventory, and battalion tracking summary tabs. True In IM ENG, TR/JT has possible returns of 0, 1, 2, 3. What does each return mean? 0 - quiet, 1 - continuous, 2 - non-continuous, 3 - repeater In which tab can you set Mode 4 Low Randomness? Tab 6 True or False; CARM Mode switch indicator invokes all of the ARM countermeasures initialized in Tab 76, page B. This switch indicator allows the operator to implement low power, authorize frequency diversity, and reduced search. True True or False; IFF results can be viewed in track amp data. True Define the brevity BIRD Which tab allows the operator to select the english or metric units of measure? Tab 14 When the ICC receives an engagement announcement and firing message from a FU, it automatically sends what command to all other units? Cease Fire True or False; On the CRT, when a priority alert is in queue, the MORE or FULL will blink to notify the operator. True Which tab provides safe passage corridor definition, definition of radial and polygon volumes, and IFFON lines? Tab 71 What are the two methods of initialization? Automatic and manual Which tab would the operator use to enable URLAT CTRL? Tab 1 True or False; The RLRIU processes and routes both voice and data. False Which tab is used to enter the width of a safe passage corridor? Tab 71 What does TVMAP stand for? Track Via Missile Analog Processor Why won't the system allow a mode 3 code of 8777 to be entered in tab 73? Max frequency for the RS is 5736 True or False; Each FP is allocated a maximum of 55 volumes in tab 61. True Which tab is used to assign multi-channel radio communications links and antenna azimuths for the units in the battalion communications net? Tab 62 Which tab is used to designate the presence of a TCS interface? Tab 62 In which tab is medium speed category limits and what does it do? Tab 14; entry establishes the speed range for the medium speed and heading target vector that protudes from each target. Which tab is used to enter the data link reference point? Tab 58 What type of communications are used to transmit data between the ICC and ECS? PADIL In what band does the Radar actively search? How many frequencies can the Radar utilize? C-banc, 160 frequencies Which tab is used to allow special information reporting? Tab 69 Explain the difference between a spurious track and a mis-classified track. Mis-class - results from a problem in system classification ie. if an ABT track's flight profile parallels that of a TBM or ARM at anytime it may be incorrectly classified. Spurious characteristics - rapid increase/decrease in altitude or speed; time on scope is brief; an abnormal flight tracjectory/parameter; erratic GIP; may appear as a low bright; flight path may be lateral across the CRT List the four types of initializations. Standard, standard w/ database read, long term, and short term True or False; The ICC can plan and enter the locations of 6 PATRIOT FP using tab 59? True Which tab is used to enter tailored TBM search data? Tab 56 Which tab is used to enter data communications to units not local to the ICC, called extra-battalion units? Tab 69 ___ is the estimated time it will take for the target approaching a FU to be engaged with an intercept occuring within an acceptable probability of kill. TTFL - Time Til First Launch In which tab can you set the julian date? Tab 6 Which tab can the operator enter information for the following general types of platforms: FGHTR/BOMB-ATTK, BOMBER, HELO, PATROL, AEW, OTHER? Tab 43 True or False; A hold fire is passed over PADIL True Which tab provides definition for display of FSCL and IFFOFF lines, general informatin lines, i.e. FEBA, FLOT, country boundaries? Tab 72 Which ICC tab does the operator set the ICC RLRIU address? Tab 67 Which tab is used for entry of the ICC location and to assist in determining the need for CRG/LCSs and their emplacement location? Tab 62 An ID weight set of 1 is used for Peacetime operations True or False; Tab 76 page B is used to enter ARM countermeasures. True Authorizations for minimum safe velocity and SIF friend are found in which tab? Tab 1 Which tab would an operator select to see the launcher allocation status of a PATRIOT FP? Tab 64 The ICC accommodates a total of ____ TBM assets and ___ ABT assets in Tab 70. 18, 36 FP locations and orientations planning are supported via tab ___ while tab ___ displays ICC, CRG, LCS, and FP planned communication links and antenna azimuths. 59, 62 Which tab can you assign minimum and maximum ARM speed parameters? Tab 76 Explain the difference between ECCM enable and CARM mode in terms of frequency hop. ECCM enable - changes when being jammed CARM mode - continuous hopping Define the brevity code No Joy Do not have visual contact with the target Define the brevity code Spades No IFF/SIF response Which of the following IFF conditions is displayed when an interrogation results in two responses spaced so close together that the IFF interrogator can not differentiate between them? MULT REPLY What is PATRIOT prime power? 208 VAC, 3-phase, 400 Hz In which tab can you correlate non-range resolved jammers? Tab 15 In which tab is the TMAT? Tab 78 Which tab displays the LCS/CRG communication status? Comm Net Status switch indicator Define the brevity code BIRD friendly SAM Which tab is used to authorize final IFF? Tab 6 How long does the ICC have to conduct emplacement? 25 minutes What is the maximum amount of tracks the ICC can hold on the CRT at one time? 352 ASM engagement mode is in this tab. Tab 78 In which tab can you convert UTM to LAT or LON? Tab 14 In which tab can you assign ASM MOF: SLS, Ripple? Tab 78 This tab transitions you from initialization to tactical. Tab 98 What tab are track block numbers entered in? Tab 67 Tab ___ allows and prohibits the ICC to make changes in the communications control and track reporting parameters for FUs. Tab 2 The database is updated in Tab ___. 13 What does ICC stand for? Information coordination central The TCOs must send which tabs to the ICC? Tab 1 pages 2 and 3, Tab 6 and Tab 78 page 1 and 3 Who must notify any non-organic commo nodes collocated with the ICC of battle stations? 25R Who must verify EDR tape is installed, record mode is on. TDA The TD verifys which tabs ___ prior to verifying HCU and air conditioners? Tabs 1, 5, 6, 14, 73, 76, 78, 79, and 90 What is the TDs most important duty? Identifying all tracks What is the difference in origin between a high bright and a low bright track? High bright tracks are tracked locally Low bright tracks are told in from external sources Which indicator is found on the battalion status panel? Equipment indicator Which switch indicator is used to display the FSCL? Masked terrain maps TBE data 1 switch indicator shows up to ___ top threats to are being defended by battalion. 9 Which swith indicator displays subordinate FPs? General points How many LTDA defended areas may be entered in tab 70 at the ICC? 12 If the ICC loses data with a fire unit and the data is re-established, what tabs are automatically updated at the FU via the ICC? Tabs 1, 6, and 78 What are the TDs two major responsibilities? Friendly protect and battalion air battle operations Who monitors and initiates all engagements? TDA Who supervises the battalion radiation schedule, unit search modes, and maintains maintenance schedules? TD Who resolves target identification and is responsible for applying all engagement overrides? TD Which console mode switch indicators should the TDA have enabled? Engage Center and equipment center Who monitors the battalion status panel and ensures that the batteries and the FDC are in the assigned engagement mode? TDA Where does the TDA get authority to order engagement when the battalion is centralized to a HEU? voice command or alert messages from higher echelon Where does the TDA get authority to engage when the battalion is decentralized? based on the ROE and supplemental fire control measures in effect What is the key element of the ICC that ensures the continuity of track data within the battalion and brigade? track management software What is correlation? the function of comparing the individual track reports What is triangulation? a strobe correlation process used to determine the target's range and provides information to the reporting fire units When is saturation alleviation invoked? when the number of tracks at the ICC is greater than a prespecified system level to ensure that the most important battalion track data record is retained What are the two types of saturation alleviation? when the number of tracks are too great when the radar is saturated with too many actions Up to how many hostile tracks can be displayed on the ICC's ENG DATA tab? 18 In tab 67, which battalion is defined as the MICC and TOD master? Assigned as battalion A or lowest lettered battalion Track correlation, site calibration, triangulation and saturation alleviation are all components of what performance measure? Track management How is the site ampliying data tab brought up? place cursor on FP or ICC then press select tab, hook, select tab What is the maximum difference between the DLRP and BNSCC? 17 degrees In which tab can you perform a retrieve and compare? Tab 50 In which tab can you see how many hostile tracks FP2 is tracking? battalion tracking summary tab What does LICC stand for? Lateral Information and Coordination Central What does BNSCC stand for? Battalion System Coordinate Center What is the tactical operating system in the ICC? BATI What 4 tabs in the ICC constatute the commo database? 2, 67, 68, & 69 In the ICC the TMAT is set in what tab and page? tab 78 page 6 What is ICC tab 72? General Purpose Maps What is ICC tab 76? Counter ARM Measures What is ICC tab 79? ID Parameters What doe the PFE S/I do? the computer will process a track for engagement and send the engage command only once the PK is at an optimal level What is ICC tab 63? Launcher Group Assignment What is ICC tab 54? Radar Frequency Control for FP What is ICC tab 51? Deployment/Command planning Control What is ICC tab 70? Asstes Defended Areas Data What pages of tab 70 are for LTDA? pages 55-66 What is ICC tab 44? TBM Threat Set Control What is ICC tab 61? Volumes Allocations On what tab and page can you find refraction perameters? tab 1 page 4 Who assigns all engagements from the TBEQ? TDA What tab would you use for correlation when 2 FP each see a strobe/jammer that is not range resolved? tab 15 In which tab can you plan all the fire platoon UTM and PTLs? tab 59 ECM wedges are used for what? to determine the approximate range of a formation of non-range-resolved jammers In the ICC where are the authorizations found? tab 1 pages 2 & 3 In order to change a subordinate units Method Of Control, where would you go? System + Weapon Control In which ICC tab would you find altitude bands? tab 14 page 2 In the ICC the TMAT would be found in what page and tab? page 6 of tab 78 In which tab is the total communications net load checked? tab 2 What tab is used to find out what W-code & frequency each units radar is running? FP Status