Manual Drive Trains and Axles Test 2023 Accurate 100%
Rated A+
An excessively low lubricant level will most likely cause ______.
a.
gear clash
b.
hard shifting
c.
gear lockup
d.
gear jump-out
c.
gear lockup
Using a lubricant that is thicker than service manual specifications can lead to ______.
a.
gear jump-out
b.
hard shifting
c.
gear lockup
d.
gear slippage
b.
hard shifting
Manual transmission/transaxle lubricants in use today include ______.
a.
automatic transmission fluids
b.
engine oils
c.
multiple viscosity gear oils
d.
All the answers are correct.
d.
All the answers are correct.
While discussing transmission/transaxle rebuilding procedures, Technician A says
shims located under bearing cups should always be replaced. Technician Bkeeps all
shims and bearing races together and identified for reinstallation in their original
location. Who is correct?
a.
A only
b.
B only
c.
,both A and B
d.
neither A nor B
b.
B only
Technician A says the transmission output shaft seal is prone to leakage. Technician B
says a worn transmission rear bushing may contribute to output shaft seal leakage.
Who is correct?
a.
A only
b.
B only
c.
both A and B
d.
neither A nor B
c.
both A and B
A rough growling noise occurs when the engine is running, the transmission is in
neutral, the clutch is engaged, and the vehicle is not moving. Technician Asays the
input shaft bearing may be faulty. Technician B says the countergear bearing may be
faulty. Who is correct?
a.
A only
b.
B only
c.
both A and B
d.
neither A nor B
c.
both A and B
A car jumps out of gear into neutral when decelerating or going down hills. Technician A
checks the shift lever and internal gearshift linkage. Technician Bsays the clutch pilot
bearing could be the problem. Who is correct?
a.
A only
b.
B only
c.
both A and B
d.
neither A nor B
c.
both A and B
, Technician A checks the transmission mounts by pushing up and down on the
transmission while observing the mounts. Technician B says if the case moves up but
not down, the mounts require replacement. Who is correct?
a.
A only
b.
B only
c.
both A and B
d.
neither A nor B
c.
both A and B
A growling noise that occurs when the transaxle is in neutral, the vehicle is not moving,
the engine is running, and the clutch is engaged is most likely caused by the ______
bearing.
a.
clutch pilot
b.
differential carrier
c.
output shaft
d.
input shaft
d.
input shaft
Which of the following will NOT cause gear clash?
a.
incorrect lubricant
b.
incorrect clutch adjustment
c.
worn countergear bearings
d.
worn synchronizer blocking rings
c.
worn countergear bearings
When installing a ball bearing that is a press fit (tight) onto the main shaft, pressure
should be applied to the _____ race.
a.
inner
b.
outer
c.
both A and B
Rated A+
An excessively low lubricant level will most likely cause ______.
a.
gear clash
b.
hard shifting
c.
gear lockup
d.
gear jump-out
c.
gear lockup
Using a lubricant that is thicker than service manual specifications can lead to ______.
a.
gear jump-out
b.
hard shifting
c.
gear lockup
d.
gear slippage
b.
hard shifting
Manual transmission/transaxle lubricants in use today include ______.
a.
automatic transmission fluids
b.
engine oils
c.
multiple viscosity gear oils
d.
All the answers are correct.
d.
All the answers are correct.
While discussing transmission/transaxle rebuilding procedures, Technician A says
shims located under bearing cups should always be replaced. Technician Bkeeps all
shims and bearing races together and identified for reinstallation in their original
location. Who is correct?
a.
A only
b.
B only
c.
,both A and B
d.
neither A nor B
b.
B only
Technician A says the transmission output shaft seal is prone to leakage. Technician B
says a worn transmission rear bushing may contribute to output shaft seal leakage.
Who is correct?
a.
A only
b.
B only
c.
both A and B
d.
neither A nor B
c.
both A and B
A rough growling noise occurs when the engine is running, the transmission is in
neutral, the clutch is engaged, and the vehicle is not moving. Technician Asays the
input shaft bearing may be faulty. Technician B says the countergear bearing may be
faulty. Who is correct?
a.
A only
b.
B only
c.
both A and B
d.
neither A nor B
c.
both A and B
A car jumps out of gear into neutral when decelerating or going down hills. Technician A
checks the shift lever and internal gearshift linkage. Technician Bsays the clutch pilot
bearing could be the problem. Who is correct?
a.
A only
b.
B only
c.
both A and B
d.
neither A nor B
c.
both A and B
, Technician A checks the transmission mounts by pushing up and down on the
transmission while observing the mounts. Technician B says if the case moves up but
not down, the mounts require replacement. Who is correct?
a.
A only
b.
B only
c.
both A and B
d.
neither A nor B
c.
both A and B
A growling noise that occurs when the transaxle is in neutral, the vehicle is not moving,
the engine is running, and the clutch is engaged is most likely caused by the ______
bearing.
a.
clutch pilot
b.
differential carrier
c.
output shaft
d.
input shaft
d.
input shaft
Which of the following will NOT cause gear clash?
a.
incorrect lubricant
b.
incorrect clutch adjustment
c.
worn countergear bearings
d.
worn synchronizer blocking rings
c.
worn countergear bearings
When installing a ball bearing that is a press fit (tight) onto the main shaft, pressure
should be applied to the _____ race.
a.
inner
b.
outer
c.
both A and B
