2.7.6 Packet Tracer - Implement Basic Connectivity
Addressing Table
Device Interface IP Address Subnet Mask
S1 VLAN 1 192.168.1.253 255.255.255.0
S2 VLAN 1 192.168.1.254 255.255.255.0
PC1 NIC 192.168.1.1 255.255.255.0
PC2 NIC 192.168.1.2 255.255.255.0
Objectives
Part 1: Perform a Basic Configuration on S1 and S2
Part 2: Configure the PCs
Part 3: Configure the Switch Management Interface
Background
In this activity, you will first create a basic switch configuration. Then, you will implement basic connectivity by
configuring IP addressing on switches and PCs. When the IP addressing configuration is complete, you will
use various show commands to verify the configuration and use the ping command to verify basic
connectivity between devices.
Instructions Part 1: Perform a Basic Configuration on S1 and S2
Complete the following steps on S1 and S2.
2013 - 2020 Cisco and/or its affiliates. All rights reserved. Cisco Public Page 1 of 4 www.netacad.com
Addressing Table
Device Interface IP Address Subnet Mask
S1 VLAN 1 192.168.1.253 255.255.255.0
S2 VLAN 1 192.168.1.254 255.255.255.0
PC1 NIC 192.168.1.1 255.255.255.0
PC2 NIC 192.168.1.2 255.255.255.0
Objectives
Part 1: Perform a Basic Configuration on S1 and S2
Part 2: Configure the PCs
Part 3: Configure the Switch Management Interface
Background
In this activity, you will first create a basic switch configuration. Then, you will implement basic connectivity by
configuring IP addressing on switches and PCs. When the IP addressing configuration is complete, you will
use various show commands to verify the configuration and use the ping command to verify basic
connectivity between devices.
Instructions Part 1: Perform a Basic Configuration on S1 and S2
Complete the following steps on S1 and S2.
2013 - 2020 Cisco and/or its affiliates. All rights reserved. Cisco Public Page 1 of 4 www.netacad.com