Measurement, Materials, and Safety (NIMS) Exam
Questions and Answers 2023 with complete solution
The safest way to remove chips from a lathe or milling machine is to use a
brush
Small chips left out on the spindle nose of a lathe should be cleaned to avoid
Run out on work holding devices
Grease guns are used to insert grease into
Zerk fittings on machine tools
To lubricate the ways of a late, the gibs of a mill, or the cross slide of a grinder
Use lubricant found in central lubricating systems ("one shots")
If a vertical mill table is loose and has side play, the best solution to alleviate side
play is to
tighten the taper gib adjustment
A machinist wants to find the proper type of lubrication, schedule and
recommended maintenance practices for the headstock of a lathe. The best
source to find this information is
Preventative maintenance schedule and machine manual
General maintenance information for machine tools and machine work area can
be found
In a general maintenance manual
Pinning refers to
Loading the file with metal chips
Files should be stored
In a toolbox separated from eachother
The best way to clean the chips out of a file is using a
File card
What is the most common injury that may occur during a filing operation?
Being stabbed with the tang (without the file handle)
The best lubricant to prevent wear and increase cutting efficiency for common
steels is
Sulfur-based oil
The process plan specifies tooling to be used by indicating
Tooling diameters and sizes
A reaming operation produces finish tears. The cause of the tears is
A reamer with a worn tip
What size gage block height for an angle of 9 degrees on a 10 in sine plate?
1.5643 in
Which of the following combinations of gage blocks (from a 81-block set) can be
used to gage a length of .9528 in?
0.1008, 0.102, .750
The process of displacing air between gage blocks for accurate measurements is
called
wringing
To check the height of multiple parts with gage blocks, a machinist would use a
Questions and Answers 2023 with complete solution
The safest way to remove chips from a lathe or milling machine is to use a
brush
Small chips left out on the spindle nose of a lathe should be cleaned to avoid
Run out on work holding devices
Grease guns are used to insert grease into
Zerk fittings on machine tools
To lubricate the ways of a late, the gibs of a mill, or the cross slide of a grinder
Use lubricant found in central lubricating systems ("one shots")
If a vertical mill table is loose and has side play, the best solution to alleviate side
play is to
tighten the taper gib adjustment
A machinist wants to find the proper type of lubrication, schedule and
recommended maintenance practices for the headstock of a lathe. The best
source to find this information is
Preventative maintenance schedule and machine manual
General maintenance information for machine tools and machine work area can
be found
In a general maintenance manual
Pinning refers to
Loading the file with metal chips
Files should be stored
In a toolbox separated from eachother
The best way to clean the chips out of a file is using a
File card
What is the most common injury that may occur during a filing operation?
Being stabbed with the tang (without the file handle)
The best lubricant to prevent wear and increase cutting efficiency for common
steels is
Sulfur-based oil
The process plan specifies tooling to be used by indicating
Tooling diameters and sizes
A reaming operation produces finish tears. The cause of the tears is
A reamer with a worn tip
What size gage block height for an angle of 9 degrees on a 10 in sine plate?
1.5643 in
Which of the following combinations of gage blocks (from a 81-block set) can be
used to gage a length of .9528 in?
0.1008, 0.102, .750
The process of displacing air between gage blocks for accurate measurements is
called
wringing
To check the height of multiple parts with gage blocks, a machinist would use a
