pipe fitter test 2023 questions and answers with complete
solution
What does TE in TE-601 stand for?
temperature element
what does B.T.U stand for?
British Thermal Unit
what is the boiling point of water?
212*F
What is 3.1416?
Pi
what is the circumference of a 15" pipe? (to the nearest tenth0
47"
4" in the hundredths of a foot is?
.33
what is the take off for a 4" x 3" LR reducing 90* ell?
6"
on isometric drawings what does RFWN mean?
raised face weld neck
what does the Pi in Pi-209 stand for?
pressure indicator
101.25' converted into inches is what?
101'-3"
if testing the shell side of an exchanger with the flat cap removed and all the
tubes on the bottom row had a steady flow of water pouring out of them, this
would indicate:
floating head gasket leaking
3/4" is equal to?
6/8
the lap joint flange is usually used when_______?
flange hold alignment is a problem
what is the number of a square feet in the surface of a steel plate 180 inches high
and 48 inches wide?
60 square feet
what device is installed between a control valve and the air supply header?
regulator
what is the most common degree of bevel on a pipe to be butt welded?
37 1/2
the three states of matter are:
solids, liquids,and gases
what is the circumference of a circle that has a 20.50 inch diameter?
64.37
extension lines should:
always touch the object being drawn
what is 23% of 1598?
solution
What does TE in TE-601 stand for?
temperature element
what does B.T.U stand for?
British Thermal Unit
what is the boiling point of water?
212*F
What is 3.1416?
Pi
what is the circumference of a 15" pipe? (to the nearest tenth0
47"
4" in the hundredths of a foot is?
.33
what is the take off for a 4" x 3" LR reducing 90* ell?
6"
on isometric drawings what does RFWN mean?
raised face weld neck
what does the Pi in Pi-209 stand for?
pressure indicator
101.25' converted into inches is what?
101'-3"
if testing the shell side of an exchanger with the flat cap removed and all the
tubes on the bottom row had a steady flow of water pouring out of them, this
would indicate:
floating head gasket leaking
3/4" is equal to?
6/8
the lap joint flange is usually used when_______?
flange hold alignment is a problem
what is the number of a square feet in the surface of a steel plate 180 inches high
and 48 inches wide?
60 square feet
what device is installed between a control valve and the air supply header?
regulator
what is the most common degree of bevel on a pipe to be butt welded?
37 1/2
the three states of matter are:
solids, liquids,and gases
what is the circumference of a circle that has a 20.50 inch diameter?
64.37
extension lines should:
always touch the object being drawn
what is 23% of 1598?
