NCCER Module 4 (Power tools) 2023 Quiz 100% Verified
when using power tools, never engage the?
trigger lock.
before replacing parts such as bits, blades or disks on any tool, you must?
make sure it is disconnected from its source or energy
most hammer drills will not hammer until pressure is?
applied to the drill bit against a surface
a pneumatic drill is commonly used?
when there is no source of electricity
never use a circular saw that does not have an upper blade guard because?
it protects workers from flying debris and from touching the spinning blade
when using a circular saw, be sure to cut on the waste side of the cut mark to
allow for the blades?
Kerf
saws with a fine blade that are excellent for delicate and intricate cutting are
called?
Saber saws
before you plug any saw into a power source, make sure?
the switch is in the off position
a saw that has a thin, one piece blade that runs around guides at either end of the
saw is a?
Band saw
a power miter saw combines a miter box with a?
Circular saw
an angle grinder is used to grind?
away hard, heavy materials and to grind surfaces such as pipes, plates or welds
the adjustable tool rest on a bench grinder should be positioned?
1/8th on and inch
a good way to check the condition of the grinding wheel on a bench grinder is to?
slide the wheel onto a rod that fits through the wheel hole
a grinder can catch on rough material edges and shift around, especially when
using rotary bits called?
Burr bits
a low-velocity fastening system that is used to drive steel pins or threaded studs
into masonry and steel is a?
Powder actuated tool
special training and certification is required before using any kind of?
Powder actuated fastening tool
before using a pneumatically powered nailer for the first time, it is important to?
read the manufacturers instructions
if a pneumatic nailer is not fired properly, before attempting repairs be sure to?
disconnect the air hose
a power tool that is well suited for breaking up concrete during demolition work is
a?
pavement breaker
when using power tools, never engage the?
trigger lock.
before replacing parts such as bits, blades or disks on any tool, you must?
make sure it is disconnected from its source or energy
most hammer drills will not hammer until pressure is?
applied to the drill bit against a surface
a pneumatic drill is commonly used?
when there is no source of electricity
never use a circular saw that does not have an upper blade guard because?
it protects workers from flying debris and from touching the spinning blade
when using a circular saw, be sure to cut on the waste side of the cut mark to
allow for the blades?
Kerf
saws with a fine blade that are excellent for delicate and intricate cutting are
called?
Saber saws
before you plug any saw into a power source, make sure?
the switch is in the off position
a saw that has a thin, one piece blade that runs around guides at either end of the
saw is a?
Band saw
a power miter saw combines a miter box with a?
Circular saw
an angle grinder is used to grind?
away hard, heavy materials and to grind surfaces such as pipes, plates or welds
the adjustable tool rest on a bench grinder should be positioned?
1/8th on and inch
a good way to check the condition of the grinding wheel on a bench grinder is to?
slide the wheel onto a rod that fits through the wheel hole
a grinder can catch on rough material edges and shift around, especially when
using rotary bits called?
Burr bits
a low-velocity fastening system that is used to drive steel pins or threaded studs
into masonry and steel is a?
Powder actuated tool
special training and certification is required before using any kind of?
Powder actuated fastening tool
before using a pneumatically powered nailer for the first time, it is important to?
read the manufacturers instructions
if a pneumatic nailer is not fired properly, before attempting repairs be sure to?
disconnect the air hose
a power tool that is well suited for breaking up concrete during demolition work is
a?
pavement breaker
